Knowledge Test Class A #2
Class A Driving Test | Washington 2024 #2 Page 5 of 7
Train for FREE online with our Washington class A license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a WA CDL class A permit in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class A requirements may vary from state to state.
50
40
20
29 . Pre-trip inspections are:
Federal and state laws require drivers to inspect their vehicles before every trip, regardless of length.
30 . What do the two systems of a dual air brake system share?
Both systems in a dual air brake systems share a single air compressor. If the air compressor is damaged, neither system will be able to operate properly.
31 . No more than ____ may be driven by a commercial driver in a seven-day period.
In Washington State, commercial drivers may be on duty for no more than 60 hours in a seven-day period.
32 . What is the maximum legal weight to be placed on a single axle?
The allowable gross weight of a bus or truck depends on its tire size, the number of axles, and the spacing of axles (or axle groups). In Washington State, the weight of a commercial vehicle is limited to no more than 20,000 pounds on any single axle.
33 . Which of the following vehicles is not exempted in requiring the driver to hold a CDL?
Subject to certain conditions, a CDL is not required to operate military vehicles, authorized emergency vehicles, farm equipment, or recreational vehicles. It is also not required for operating a straight truck that contains only your personal property that you are not selling.
34 . In a dual air brake system, if one air system is very low on pressure:
In a dual air brake system, either the front or rear brakes will not be fully operable if one of the air systems gets too low on pressure. If the air pressure in either tank gets too low while you are driving, you should exit the road and park as soon as possible.
35 . When driving a 50-foot truck at 50 mph, your minimum following distance should be:
At speeds below 40 mph, you should allow at least one second of following distance for every 10 feet of your vehicle. When traveling at higher speeds, follow the same formula, then add one additional second to your following distance.
2024 Washington | Frequently Asked Questions
A CDL Class A license in Washington is defined as a commercial driver's license that allows the holder to operate any combination of vehicles with a Gross Vehicle Weight Rating (GVWR) of 26,001 pounds or more, given that the GVWR of the vehicle(s) being towed is in excess of 10,000 pounds.
A Class A Commercial Driver's License (CDL) in Washington allows the holder to operate any combination of vehicles with a Gross Vehicle Weight Rating (GVWR) of 26,001 pounds or more, provided the GVWR of the vehicle(s) being towed exceeds 10,000 pounds. This includes but is not limited to tractor-trailers, truck and trailer combinations, and tank vehicles.
To obtain a Class A CDL license in Washington, you must be at least 18 years old (21 for interstate driving), possess a valid Washington state driver's license, pass a vision test, and pass knowledge and skills tests. You'll also need to provide proof of U.S. citizenship or lawful permanent residency, and meet medical requirements.
In Washington, you must be at least 18 years old to qualify for a Class A Commercial Driver's License (CDL) for intrastate driving (within Washington only). However, federal regulations require drivers to be at least 21 years old to drive a commercial vehicle interstate (across state lines) or to haul hazardous materials.
While not always required, specific endorsements may be necessary for a Class A CDL license depending on the type of vehicle you'll operate or cargo you'll carry. These can include endorsements for double/triple trailers, tanker vehicles, passenger vehicles, or hazardous materials. Each endorsement requires additional knowledge tests and sometimes a skills test.
The Class A CDL skills test in Washington encompasses three parts: the pre-trip inspection, basic vehicle controls, and on-road driving. The pre-trip inspection checks your ability to assess your vehicle's safety. Basic vehicle controls assess your ability to maneuver and control the vehicle. The on-road driving test evaluates your driving skills in various traffic situations.
Yes, Class A CDL license holders in Washington may face limitations based on their specific endorsements and restrictions. For instance, without the proper endorsements, they cannot operate vehicles with air brakes, transport passengers, or haul hazardous materials. Additionally, restrictions may be placed on licenses due to medical conditions or lack of skills.
Yes, it is possible to take the written Class A CDL test in languages other than English in Washington. The Department of Licensing offers the test in several languages. However, federal regulations require anyone applying for a commercial driver license (CDL) to understand and read English to ensure safety on the roads.
Yes, you can request accommodations for the Class A CDL written test if you have a disability. Washington's Department of Licensing is committed to providing equal access to its services. If you have special needs, contact your local driver licensing office to discuss your situation and determine what accommodations can be made.
If you don't pass the Class A CDL written test in Washington, you can retake it. However, you must wait at least one day before retaking the test. Keep in mind that there may be additional fees for each attempt. It's advisable to study thoroughly before retaking the test to increase your chances of passing.