Knowledge Test Class A #1
Class A Driving Test | Washington 2025 #1 Page 4 of 7
Train for FREE online with our Washington class A license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a WA CDL class A permit in 2025, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class A requirements may vary from state to state.
50
40
20
22 . Bracing is used to:
Blocking and bracing are used to prevent cargo from shifting in transit. Blocking is used in the front, in the back, and on the sides of a piece of cargo to prevent movement. Bracing prevents movement by reaching from the upper portion of a piece of cargo to the floor and sides of the cargo compartment.
23 . Who can approve an oversized vehicle?
The Washington State Department of Transportation may issue permits to allow oversized and overweight vehicles (other than school buses) to operate on state highways.
24 . Having ABS on only one axle:
If you have an Anti-Lock Braking System (ABS) equipped on only the tractor, only the trailer, or only one axle, you will still have more control over the vehicle when braking than you would without ABS. You should brake normally.
25 . Do not base your decision to shift gears on:
One way to know when it is time to shift gears is to learn your vehicle's operating rpm range. You should shift up when your engine reaches the top of that range. You can also learn which speeds each gear is good for and shift up based on your speedometer.
26 . If you are taking the driving test and the route does not include a railroad crossing, you:
During the on-road driving test, if your route does not include a railroad crossing, the examiner may ask you to explain and demonstrate the necessary procedures at a simulated location.
27 . No more than ____ may be driven by a commercial driver in a seven-day period.
In Washington State, commercial drivers may be on duty for no more than 60 hours in a seven-day period.
28 . Eating while driving:
Eating while driving can be a dangerous distraction to the driver both because it diverts their attention away from the task at hand and requires them to remove a hand from the steering wheel.
Search the best driving school in your neighbourhood
2025 Washington | Frequently Asked Questions
A CDL Class A license in Washington is defined as a commercial driver's license that allows the holder to operate any combination of vehicles with a Gross Vehicle Weight Rating (GVWR) of 26,001 pounds or more, given that the GVWR of the vehicle(s) being towed is in excess of 10,000 pounds.
A Class A Commercial Driver's License (CDL) in Washington allows the holder to operate any combination of vehicles with a Gross Vehicle Weight Rating (GVWR) of 26,001 pounds or more, provided the GVWR of the vehicle(s) being towed exceeds 10,000 pounds. This includes but is not limited to tractor-trailers, truck and trailer combinations, and tank vehicles.
To obtain a Class A CDL license in Washington, you must be at least 18 years old (21 for interstate driving), possess a valid Washington state driver's license, pass a vision test, and pass knowledge and skills tests. You'll also need to provide proof of U.S. citizenship or lawful permanent residency, and meet medical requirements.
In Washington, you must be at least 18 years old to qualify for a Class A Commercial Driver's License (CDL) for intrastate driving (within Washington only). However, federal regulations require drivers to be at least 21 years old to drive a commercial vehicle interstate (across state lines) or to haul hazardous materials.
While not always required, specific endorsements may be necessary for a Class A CDL license depending on the type of vehicle you'll operate or cargo you'll carry. These can include endorsements for double/triple trailers, tanker vehicles, passenger vehicles, or hazardous materials. Each endorsement requires additional knowledge tests and sometimes a skills test.
The Class A CDL skills test in Washington encompasses three parts: the pre-trip inspection, basic vehicle controls, and on-road driving. The pre-trip inspection checks your ability to assess your vehicle's safety. Basic vehicle controls assess your ability to maneuver and control the vehicle. The on-road driving test evaluates your driving skills in various traffic situations.
Yes, Class A CDL license holders in Washington may face limitations based on their specific endorsements and restrictions. For instance, without the proper endorsements, they cannot operate vehicles with air brakes, transport passengers, or haul hazardous materials. Additionally, restrictions may be placed on licenses due to medical conditions or lack of skills.
Yes, it is possible to take the written Class A CDL test in languages other than English in Washington. The Department of Licensing offers the test in several languages. However, federal regulations require anyone applying for a commercial driver license (CDL) to understand and read English to ensure safety on the roads.
Yes, you can request accommodations for the Class A CDL written test if you have a disability. Washington's Department of Licensing is committed to providing equal access to its services. If you have special needs, contact your local driver licensing office to discuss your situation and determine what accommodations can be made.
If you don't pass the Class A CDL written test in Washington, you can retake it. However, you must wait at least one day before retaking the test. Keep in mind that there may be additional fees for each attempt. It's advisable to study thoroughly before retaking the test to increase your chances of passing.
