Tank #2
Tank Endorsement Test | Pennsylvania 2024 #2 Page 2 of 3
Train for FREE with our Pennsylvania tank endorsement practice test online. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a PA tank license in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that DMV requirements for issuing a CDL tank vehicle endorsement may vary from state to state.
20
16
20
8 . An applicant has ____ to pass the HazMat recertification test before they will be required to obtain a learner’s permit.
Four chances
As with any CDL test, you can take the HazMat recertification test up to three times. After a third failure, you will have to obtain a learner's permit and take the HazMat knowledge test.
9 . When looking under your vehicle's hood during a pre-trip inspection, you should:
Disconnect the radiator.
Before inspecting under a vehicle's hood, make sure the parking brake is engaged and/or the wheels are properly chocked.
10 . When preparing to enter traffic, you should do all of the following, except:
Assume other drivers will make room for your much larger vehicle.
When crossing or entering traffic, bear in mind the size of your vehicle and the distance it will need to accelerate. Wait for a gap in traffic that is large enough to accommodate your vehicle before you begin to accelerate. Remember that you will need more room to accelerate if your vehicle is heavily loaded. Before crossing a road, be sure that you can get all the way across without interfering with traffic.
11 . If a tire fails, the driver should:
Accelerate.
If a tire fails, braking could cause a loss of control. Unless braking is necessary to avoid a hazard, you should stay off the brakes until your vehicle has slowed considerably. Only then should you brake very gently, pull off the road, and stop.
12 . A burning tire should be:
Covered with a tarp.
A burning tire should be cooled with water. A driver may need to use large quantities of water to properly cool the tire.
13 . A pre-trip inspection includes ____ basic steps.
Nine
There are seven basic steps to a pre-trip inspection. These steps include completing an overview of the vehicle; checking the engine compartment; starting the engine and inspecting inside the cab; turning off the engine and checking the lights; a walk-around inspection; checking the signal lights; and starting the engine and checking the brakes.
14 . During a pre-trip inspection, what is the best method for checking your lights?
Driving in traffic and waiting for other drivers to let you know your lights are out