Tank #2
Tank Endorsement Test | Oregon 2025 #2
Train for FREE with our Oregon tank endorsement practice test online. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a OR tank license in 2025, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that DMV requirements for issuing a CDL tank vehicle endorsement may vary from state to state.
20
16
20
1 . When passing another vehicle, you should:
Not use a turn signal.
When passing a pedestrian or another vehicle, you should assume that they don't see you.
2 . After a tire has been changed, the driver should stop after a short distance to:
After a tire has been changed, the driver should stop a short distance later to recheck the tightness of the tire's lug nuts.
3 . Which of the following is not a tire problem to check for and avoid?
All tires are made by the same company
During an inspection, there are a number of tire problems to check for and avoid. Look for air pressure that is too low or too high; excessive wear; cuts or other damage; tread separation; dual tires that come into contact with each other or other parts of the vehicle; mismatched tire sizes; radial and bias-ply tires used together; cut or cracked valve stems; and regrooved, recapped, or retreaded tires on the front wheels of a school bus.
4 . Without oil in its engine:
A vehicle's gas mileage will improve.
An engine can be rapidly destroyed if it is run without oil. If its oil pressure gauge is low or fluctuating, do not operate a vehicle.
5 . Steering wheel play should be no more than:
A steering wheel should have no more than 10 degrees of play. This is equal to about two inches of movement at the rim of a 20-inch wheel. If there is more play than this, it may be difficult to steer.
6 . When checking tires, finding which of the following is not a cause for concern?
When checking your vehicle's tires, you should confirm that air pressure is neither too low nor too high; that there is at least 4/32 of an inch of tread depth in every major groove on the front tires; and that radial and bias-ply tires are not used together.
7 . The suspension system:
Lightens the load for the tires.
