Knowledge Test Class A #2
Class A Driving Test | Utah 2026 #2 Page 7 of 7
Train for FREE online with our Utah class A license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a UT CDL class A permit in 2026, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class A requirements may vary from state to state.
50
40
20
43 . When asked to complete a conventional parallel parking maneuver, you should:
Back into the parking space without passing it first.
You may be asked to complete a conventional parallel parking maneuver into a parking space that is to the right of your vehicle. You should drive past the parking space before backing into it while bringing the rear of your vehicle as close to the rear of the space as possible. Your vehicle should be completely within the boundaries of the space.
44 . Dual tires should be in contact with each other.
When inspecting a vehicle's tires, you should ensure that dual tires do not come into contact with each other or with other parts of the vehicle.
45 . A low air pressure warning signal should activate:
When tank pressure falls below 5 psi.
In an air brake system, a low air pressure warning signal must come on if air pressure in the tanks falls below 60 psi. This warning signal may come in the form of a light, a buzzer, or a wig wag.
46 . Header boards:
Front-end header boards, also known as "headache racks," protect the driver from cargo moving in the event of a crash or emergency stop.
47 . If a CMV driver operates a CMV with a detectable blood alcohol concentration (BAC) that is lower than 0.04 percent, they will be:
Told to drive home.
If you are found to be operating a CMV with any detectable amount of alcohol in your system, but you are still below the legal limit of 0.04 percent, you will be placed out-of-service for 24 hours. It is both illegal and dangerous to operate a motor vehicle while under the influence of alcohol.
48 . What is a danger of rolling back when you start to accelerate?
You may lose your position in traffic.
To avoid hitting someone or something behind you, it is important to ensure that your vehicle does not roll backwards when starting from a stop. If your vehicle has a manual transmission, partly engage the clutch before taking your foot off the brake.
49 . Alcohol is removed from the body:
More quickly if the person stays awake.
The liver removes alcohol from the body at a fixed rate that cannot be accelerated through common tricks, such as drinking coffee or taking a cold shower. The only way to sober up after drinking is to give your body the time it requires to process the alcohol out of your system.
50 . Which of the following statements is correct?
Welded repairs are acceptable for wheels on rear axles.
Missing clamps, spacers, studs, or lugs can be a dangerous defect. Mismatched, bent, or cracked lock rings are not safe to be used. Wheels or rims with welded repairs are not safe.
See the exact questions that will be on the 2026 Utah DMV exam.
99.2% of people who use the cheat sheet pass the FIRST TIME
Lillian MCcranie explains how our CDL study guide was helpful in passing the exam and recommends it to everyone.
Cameron tells us how he purchased the CDL exam, and found it to be a useful tool which helped him pass the exam and find a job.
2026 Utah | Frequently Asked Questions
To secure a CDL Doubles/Triples endorsement in Utah, you first need a valid Commercial Driver's License (CDL). Next, study the Doubles and Triples section of the Utah CDL handbook. Then, schedule and pass the Doubles/Triples knowledge test at a Driver License Division office. After passing the test, you'll receive your endorsement. Remember, driving experience with these types of vehicles is beneficial.
To obtain a CDL Doubles/Triples license, you need a valid Commercial Driver's License (CDL). Study the Doubles and Triples section of your state's CDL handbook. Then, schedule and pass the Doubles/Triples knowledge test at your local driving license office. Upon passing, you will receive your endorsement. It's also recommended to have hands-on experience with these types of vehicles.
While it's not a legal requirement to have specialized experience or training for a CDL Doubles/Triples endorsement, it's highly recommended. This is because driving these types of vehicles requires specific skills. Studying the Doubles/Triples section of the CDL handbook and passing the knowledge test is mandatory, but practical experience can significantly improve safety and confidence.
Yes, to receive a CDL Doubles/Triples endorsement in Utah, you must pass an additional written knowledge test specifically for Doubles/Triples. This test covers the special procedures and safety considerations associated with operating these types of vehicles. It is separate from the general CDL written test. You can prepare by studying the Doubles/Triples section of your state's CDL handbook.
For the CDL Doubles/Triples endorsement, there isn't a specific skills or maneuvers test as there is with the basic CDL. The endorsement only requires a written knowledge test. However, the test will cover topics like coupling and uncoupling, inspecting doubles and triples, and managing the vehicles during different situations. These are skills you'll need to safely operate these vehicles.
No, it is not permissible to operate double or triple trailers without a valid CDL Doubles/Triples endorsement in Utah. The endorsement is required by federal and state law to ensure that drivers have the necessary skills and knowledge to safely operate these types of vehicles. Driving without the appropriate endorsement can result in fines and penalties.
You can append the CDL Doubles/Triples endorsement to your current commercial driver's license. You don't need to initiate a new application for a CDL. However, you'll need to pass the Doubles/Triples knowledge test. After passing, the endorsement will be added to your existing CDL. Remember, there's no skills test for this endorsement in Utah.
Yes, there are some limitations for drivers with a CDL Doubles/Triples endorsement. For instance, they can only drive vehicles that their base CDL allows. Additionally, all federal and state regulations regarding hours of service, vehicle maintenance, and safety inspections must be followed. Violating these rules can result in penalties or loss of the endorsement.
In Utah, double trailers can be up to 81 feet long and triple trailers up to 105 feet long. The maximum weight for both is 129,000 pounds. However, these limits can vary depending on the specific highways and routes used. Drivers should always check local regulations and restrictions before operating these types of vehicles.
Yes, drivers with a CDL Doubles/Triples endorsement must follow specific safety guidelines. These include checking that all couplings are secure, maintaining extra following distance, and taking wider turns to avoid trailer off-tracking. Also, they must be aware of the "crack-the-whip" effect, which can cause a rollover. Federal regulations also apply, such as hours-of-service rules.
