FREE Air Brakes Endorsement Test Online | Utah 2024
Train for FREE online with our Utah CDL air brake test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a UT Class A/Class B driver license in 2021, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that the requirements for CDL may vary from state to state.
25
20
20
1 . Truck tractors with air brakes that were built on or after March 1, 1997 are equipped with:
Anti-Lock Braking Systems (ABS).
Truck tractors with air brakes that were manufactured on or after March 1, 1997 are required to be equipped with Anti-Lock Braking Systems (ABS). ABS is required in any other type of vehicle with air brakes that was manufactured on or after March 1, 1998.
2 . When using the controlled braking method in an emergency situation, you should:
Apply the brakes with minimal pressure.
The controlled braking method for emergency stops involves applying the brakes as hard as you can without locking the wheels. Keep steering wheel movements small when braking in this way.
3 . Some air brake systems use alcohol:
To reduce the risk of rust forming on air brake valves.
Some air brake systems contain an alcohol evaporator. This device introduces alcohol into the braking system to inhibit the formation of ice.
4 . Air tank drains:
Must remain open while driving.
Compressed air in an air brake system usually contains a certain amount of water and compressor oil. The water and oil can damage the brakes if left to accumulate in the system. Manually operated air tank drains must be opened daily to remove this build-up.
5 . What happens if the air pressure in a system's air tanks falls below 60 psi?
The vehicle should stop.
In an air brake system, a low pressure warning signal should activate if the pressure in the air tanks falls to a level below 60 psi. This signal may be in the form of a warning light or a wig wag.
6 . When traveling down a steep downgrade:
The vehicle should be driven on the shoulder.
On a downgrade, the braking effect of the engine should be your primary method of controlling speed. Shift down to a lower gear before starting down the hill and save the brakes for additional slowing or stopping that may be required by road or traffic conditions.
2024 Utah | Frequently Asked Questions
A CDL Class A license in Utah is defined as a commercial driver's license that allows the holder to operate any combination of vehicles with a gross combination weight rating (GCWR) of 26,001 pounds or more, provided the towed vehicle(s) weigh more than 10,000 pounds. It includes vehicles like tractor-trailers, truck and trailer combinations, and flatbeds.
A Class A CDL license allows you to operate a variety of large vehicles such as tractor-trailers, truck and trailer combinations, tank vehicles, livestock carriers, and flatbeds. This license is also required for operating vehicles that tow trailers or other vehicles with a GVWR of over 10,000 pounds.
To obtain a Class A CDL license in Utah, you must be at least 18 years old for intrastate driving, or 21 for interstate. You need a valid Utah driver’s license, pass a vision exam, and obtain a medical certificate. You must also pass written knowledge tests and a three-part skills test, which includes a pre-trip vehicle inspection, a basic controls test, and a driving test.
In Utah, you must be at least 18 years old to qualify for a Class A Commercial Driver's License (CDL) for intrastate (within the state) driving. However, to drive interstate (across state lines), transport hazardous materials, or drive a school bus, you must be at least 21 years old.
Specific endorsements are not required for a Class A CDL license, but they can provide additional driving privileges. Endorsements include: H (Hazardous Materials), N (Tank Vehicles), P (Passenger Transport), S (School Buses), T (Double/Triple Trailers), and X (Combination of Tank Vehicle and Hazardous Materials). Each endorsement requires passing a specific knowledge test.
The Class A CDL skills test in Utah includes three parts: a pre-trip vehicle inspection, a basic controls test, and a driving test. The pre-trip inspection assesses your ability to inspect your vehicle before driving. The basic controls test evaluates your ability to maneuver and control the vehicle. The driving test evaluates your on-road driving skills.
Yes, limitations can be imposed on Class A CDL license holders in Utah. These restrictions are based on the driver's abilities and the type of vehicle they tested in. For instance, if a driver takes the skills test in a vehicle without air brakes, they will have an "L" restriction, indicating they are not authorized to operate vehicles with air brakes.
In Utah, the written Class A CDL test is primarily offered in English. However, some locations may offer the test in Spanish as well. It's important to note that federal regulations require all commercial drivers to read and speak English sufficiently to converse with the general public, understand highway signs and signals, respond to official inquiries, and make entries on reports and records.
Yes, accommodations can be provided for the Class A CDL written test for individuals with disabilities in Utah. The state complies with the Americans with Disabilities Act (ADA). You'll need to provide documentation of your disability and specify your required accommodation when scheduling your test. It's recommended to contact the Utah Driver License Division for detailed procedures.
Yes, you can retake the Class A CDL written test in Utah if you don't pass it the first time. However, you must wait until the next day to retake it. There's also a retest fee that you'll have to pay each time you retake the test. It's advisable to study thoroughly before reattempting to increase your chances of passing.