Knowledge Test Class A #1
Class A Driving Test | Utah 2026 #1 Page 5 of 7
Train for FREE online with our Utah class A license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a UT CDL class A permit in 2026, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class A requirements may vary from state to state.
50
40
20
29 . Alcohol is removed from the body:
More quickly if the person stays awake.
The liver removes alcohol from the body at a fixed rate that cannot be accelerated through common tricks, such as drinking coffee or taking a cold shower. The only way to sober up after drinking is to give your body the time it requires to process the alcohol out of your system.
30 . Noting the engine speed is one way to determine when to upshift.
There are two indicators that determine when you need to shift into a higher gear. One indicator is the engine speed (rpm). You should read your vehicle's manual to learn its rpm range and shift up when you reach the top of that range. The other indicator is road speed (mph). You should learn which speeds each gear can accommodate, then keep an eye on the speedometer and shift up as needed.
31 . When going downhill, switching into a lower gear is an effective way to slow a vehicle.
On a steep downgrade, you must use the engine's braking effect as your primary method of speed control. Be sure to decelerate and downshift appropriately before beginning to drive down the hill.
32 . A rear tire with a tread depth of 1/32 an inch is acceptable.
Tires need to have at least 4/32 of an inch of tread depth in every major groove on the front tires, and at least 2/32 of an inch of tread depth on other tires.
33 . A person working on a disabled vehicle on the shoulder of a road:
Should not be assisted.
Be cautious when driving near people who are working on disabled vehicles. The task will likely consume their attention, so they may not be aware of traffic or other hazards on the road.
34 . Which of the following is not required safety equipment?
All commercial motor vehicles are required to be equipped with the proper emergency equipment. This may include spare electrical fuses; three red reflective triangles, six fuses, or three liquid burning flares; and at least one properly charged and rated fire extinguisher.
35 . When switching gears, what happens if you remain in neutral for too long?
The vehicle will be difficult to stop.
Remaining in neutral for too long when shifting gears may make it difficult to put the vehicle into the next gear.
Search the best driving school in your neighbourhood
2026 Utah | Frequently Asked Questions
A CDL Class A license in Utah is defined as a commercial driver's license that allows the holder to operate any combination of vehicles with a gross combination weight rating (GCWR) of 26,001 pounds or more, provided the towed vehicle(s) weigh more than 10,000 pounds. It includes vehicles like tractor-trailers, truck and trailer combinations, and flatbeds.
A Class A CDL license allows you to operate a variety of large vehicles such as tractor-trailers, truck and trailer combinations, tank vehicles, livestock carriers, and flatbeds. This license is also required for operating vehicles that tow trailers or other vehicles with a GVWR of over 10,000 pounds.
To obtain a Class A CDL license in Utah, you must be at least 18 years old for intrastate driving, or 21 for interstate. You need a valid Utah driver’s license, pass a vision exam, and obtain a medical certificate. You must also pass written knowledge tests and a three-part skills test, which includes a pre-trip vehicle inspection, a basic controls test, and a driving test.
In Utah, you must be at least 18 years old to qualify for a Class A Commercial Driver's License (CDL) for intrastate (within the state) driving. However, to drive interstate (across state lines), transport hazardous materials, or drive a school bus, you must be at least 21 years old.
Specific endorsements are not required for a Class A CDL license, but they can provide additional driving privileges. Endorsements include: H (Hazardous Materials), N (Tank Vehicles), P (Passenger Transport), S (School Buses), T (Double/Triple Trailers), and X (Combination of Tank Vehicle and Hazardous Materials). Each endorsement requires passing a specific knowledge test.
The Class A CDL skills test in Utah includes three parts: a pre-trip vehicle inspection, a basic controls test, and a driving test. The pre-trip inspection assesses your ability to inspect your vehicle before driving. The basic controls test evaluates your ability to maneuver and control the vehicle. The driving test evaluates your on-road driving skills.
Yes, limitations can be imposed on Class A CDL license holders in Utah. These restrictions are based on the driver's abilities and the type of vehicle they tested in. For instance, if a driver takes the skills test in a vehicle without air brakes, they will have an "L" restriction, indicating they are not authorized to operate vehicles with air brakes.
In Utah, the written Class A CDL test is primarily offered in English. However, some locations may offer the test in Spanish as well. It's important to note that federal regulations require all commercial drivers to read and speak English sufficiently to converse with the general public, understand highway signs and signals, respond to official inquiries, and make entries on reports and records.
Yes, accommodations can be provided for the Class A CDL written test for individuals with disabilities in Utah. The state complies with the Americans with Disabilities Act (ADA). You'll need to provide documentation of your disability and specify your required accommodation when scheduling your test. It's recommended to contact the Utah Driver License Division for detailed procedures.
Yes, you can retake the Class A CDL written test in Utah if you don't pass it the first time. However, you must wait until the next day to retake it. There's also a retest fee that you'll have to pay each time you retake the test. It's advisable to study thoroughly before reattempting to increase your chances of passing.
