When checking your vehicle's pedals during a pre-trip inspection, you should ensure that there is nothing under or around the pedals that will obstruct their use. Make sure the pedals are in proper working condition and that the surfaces of the pedals are grooved, if applicable.

The grooved pedal surface has not been smoothed out.

When inspecting an exhaust system, you should verify that parts of the system are not loose, broken, or missing. The system's parts must be properly mounted and should not be rubbing against moving parts of the vehicle.

Rubbing against other parts of the vehicle.

Federal, state, and local regulations governing commercial vehicle loads vary from place to place. Be sure that you are always aware of the laws for the state in which you are driving.

The laws of the state in which the vehicle is physically located take precedence.

The laws of the state where the trip originated take precedence.

The laws of the state in which the vehicle is physically located take precedence.

The driver can choose which state’s laws to follow.

During a pre-trip inspection, you should check for emergency equipment, including spare electrical fuses; three red reflective triangles, six fuses, or three liquid burning flares; and at least one properly charged and rated fire extinguisher.

Only required for vehicles that are transporting hazardous materials.

Only required during interstate travel.

Some older vehicles have front brake limiting valves with "normal" and "slippery" settings. Setting a brake limiting valve to "slippery" reduces the vehicle's stopping power, so a driver should make sure the valve is in its "normal" position. Front wheel braking has proven to be effective in all driving conditions.

Set the control to the off position.

Set the control to the neutral position.

Friction inside a brake drum is caused when the brake shoes and linings push against the inside of the drum. The friction in the drums will slow and stop the vehicle.

Press against the inside of the brake drum.

Press against the outside of the brake drum.

Press against the inside of the brake drum.

Class A Driving Test | Idaho 2024 #2 Page 3 of 7

Train for FREE online with our Idaho class A license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a ID CDL class A permit in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class A requirements may vary from state to state.

Number of Question 50

Passing Score 40

Number of Tests 20

Class A Driving Test | Idaho 2024 #2 Page 3 of 7

15 . Before a trip, you should make sure that:

16 . Exhaust system parts should be:

17 . During a pre-trip inspection, belts should be:

18 . Regulations regarding commercial vehicle weight and load securement may vary from state to state. Regarding these regulations:

19 . Emergency equipment in a vehicle is:

20 . To ensure normal stopping power, drivers of vehicles equipped with a front brake limiting valve should:

21 . Friction in an S-cam brake is caused when the brake shoes and linings:

See the exact questions that will be on the 2024 DMV exam.

Wait, before you go