Knowledge Test Class A #1
Class A Driving Test | Georgia 2024 #1 Page 5 of 7
Train for FREE online with our Georgia class A license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a GA CDL class A permit in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class A requirements may vary from state to state.
50
40
20
29 . During a basic vehicle control skills test, what is considered a look?
A driver glancing over their shoulder to check blind spots
A driver uses a look when they open their door, leave their seated position, and walk to the back of the vehicle to check its position. During the straight line backing exercise, a driver may not exceed one look. During any other exercise, a driver may not exceed two looks.
30 . While driving downhill, you should brake until you reach a speed that is ____ below your safe speed, then release the brake pedal.
20 mph
While driving downhill, you should hold down the brake pedal until your vehicle reaches a speed 5 mph below your safe speed, then release the brake pedal. Repeat this process.
31 . Which of the following is not an offense that would result in the loss of a CDL for at least one year?
Operating a CMV for more than 10 hours in a day
There are a number of offenses for which a first conviction will result in the loss of one's CDL for at least one year. These offenses include driving a CMV if your blood alcohol concentration (BAC) is 0.04 percent or higher; refusing a blood alcohol test if requested by authorities; leaving the scene of an accident involving a CMV; and operating a CMV while your CDL is suspended.
32 . If carrying a heavy load that is slowing you down, you should:
Keep the vehicle in second gear.
The right lanes of a roadway are generally intended for vehicles traveling more slowly than surrounding traffic. If being slowed down by a heavy load, you should stay in the right lane.
33 . When driving through a work zone, you should:
Steer with one hand to keep the other hand free.
In work zones, you should observe posted speed limits. Slow down if road or weather conditions are poor, and slow down even further if workers are near the roadway.
34 . When checking your tires, which of the following is not an issue to correct?
Tread depth of at least 4/32 of an inch on the front tires
Problems to check for when inspecting tires include: air pressure that is too low or too high; using radial and bias-ply tires together; tread depth of less than 4/32 of an inch in major grooves on front tires; and tread depth of less than 2/32 of an inch on all other tires.
35 . Rust around wheel nuts may mean:
The nuts are too tight.
