Combination #2
Combination Vehicles Practice Test | Georgia 2024 #2
Train for FREE online with our Georgia CDL combination vehicle test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a GA combination license in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that DMV requirements for issuing a combination license may vary from state to state.
20
16
20
1 . To help prevent rollovers, you should:
Keep the load on one side of the trailer.
To lower the risk of a rollover, load your cargo as closely to the ground as possible. To further reduce this risk, take curves and corners slowly.
2 . Air pressure in the ____ air line is controlled by either the foot brake or trailer hand brake.
Auxiliary
Air pressure in the service air line is controlled by either the foot brake or trailer hand brake. The service air line is also known as the control line or signal line. This line is connected to relay valves, which allow the trailer brakes to be applied more quickly than would otherwise be possible.
3 . To prevent a rollover, a driver should:
Turn quickly.
Rollovers can happen when a combination vehicle is turned too quickly. To help prevent the risk of rollover, it is important to keep the vehicle's center of gravity low by loading cargo as close to the ground as possible.
4 . The trailer hand valve should be used:
To test the lights on the trailer.
The trailer hand valve, also called the trolley valve or Johnson bar, is used to work the trailer brakes. It should be used only to test the brakes.
5 . Using the trailer hand brake while experiencing a trailer jackknife will:
Continue the skid.
If you are experiencing a trailer jackknife, you can help your tires regain traction by releasing the brakes. Using a trailer hand brake while experiencing a skid will only cause the skid to continue.
6 . When backing up to couple a trailer, you should position the tractor:
At a 60-degree angle in front of the trailer.
When backing up to couple a trailer, you should position the tractor directly in front of the trailer. Trying to couple while backing at an angle could cause the trailer to move and the landing gear to break.
7 . Push in the trailer air supply control to:
Supply the trailer with air.
