Knowledge Test Class A #2
Class A Driving Test | Alabama 2024 #2 Page 2 of 7
Train for FREE online with our Alabama class A license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a AL CDL class A permit in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class A requirements may vary from state to state.
50
40
20
8 . A commercial motor vehicle driver:
If you choose to use a mobile phone while operating a CMV, you may only use a hands-free mobile phone that is located close to you. However, even a hands-free mobile phone can be a dangerous distraction while driving. Make sure you are aware of all cell phone laws in the state in which you are driving.
9 . The two indicators that determine when you should upshift are:
Oil pressure and air brake pressure.
There are two indicators that determine when you need to shift into a higher gear. One indicator is the engine speed (rpm). You should read your vehicle's manual to learn its rpm range and shift up when you reach the top of that range. The other indicator is road speed (mph). You should learn which speeds each gear can accommodate, then keep an eye on the speedometer and shift up as needed.
10 . An after-trip inspection should be done:
You should always complete an after-trip inspection of your vehicle at the end of a trip, day, or tour of duty. Complete a vehicle inspection report, if required.
11 . During an applied leakage test, the maximum leakage rate for a single vehicle with air brakes is:
4 psi in one minute.
It is important to know the maximum air loss rate that is safe for your specific vehicle. A single vehicle with air brakes should have a leakage rate no higher than 3 psi in a minute during an applied leakage test.
12 . When pulled over to the side of the road, you should:
When stopped on the side of the road, be sure to turn on your vehicle's four-way emergency flashers, especially during times of lowered visibility. Place warning devices within 10 minutes of being stopped.
13 . If there are no warning gates or lights at a railroad crossing, you should:
Do whatever surrounding vehicles are doing.
A passive railroad crossing is a crossing that lacks control devices, like gates or warning lights. Before crossing a passive railroad crossing, you should search the tracks for approaching trains coming from either direction.
14 . When driving under wet conditions, a lack of spray coming from the tires of other vehicles indicates that:
In wet conditions, a lack of spray coming from the tires of other vehicles indicates that ice has formed on the road. Be especially cautious when traveling under wet conditions in freezing weather.
2024 Alabama | Frequently Asked Questions
A CDL Class B license in Alabama allows the driver to operate single vehicles with a gross vehicle weight rating (GVWR) of 26,001 or more pounds, or any such vehicle towing a vehicle not in excess of 10,000 pounds GVWR. This includes straight trucks, buses, large passenger vehicles, segmented buses, and trucks towing smaller vehicles.
In Alabama, a Class B CDL license permits the operation of single vehicles with a gross vehicle weight rating (GVWR) of 26,001 or more pounds, or towing a vehicle not exceeding 10,000 pounds GVWR. This includes large buses, segmented buses, straight trucks, and trucks towing smaller vehicles such as a small trailer or boat.
To acquire a Class B CDL license in Alabama, applicants must be at least 21 years old (or 18 for intrastate travel), possess a valid Alabama driver's license, pass a vision test, and complete a written knowledge test. They must also complete a skills test in a vehicle representative of the class of CDL they are applying for.
In Alabama, you must be at least 21 years old to qualify for a Class B CDL license for interstate commerce. However, if you only intend to drive within the state (intrastate commerce), you can qualify for a Class B CDL license at 18 years old.
Specific endorsements aren't necessary for a Class B CDL license, but they can provide additional driving privileges. For instance, endorsements for passenger vehicles, school buses, tank vehicles, or hazardous materials can be added to a Class B CDL after passing specific written and skills tests. These endorsements broaden the range of vehicles you can operate.
The Class B CDL skills assessment in Alabama includes three parts: the vehicle inspection test, the basic controls test, and the road test. The vehicle inspection test assesses your ability to determine if your vehicle is safe to drive. The basic controls test evaluates your ability to maneuver and control the vehicle. Lastly, the road test assesses your on-road driving skills.
Yes, Class B CDL license holders in Alabama are limited to operating single vehicles with a gross vehicle weight rating (GVWR) of 26,001 pounds or more, or a vehicle towing another vehicle not exceeding 10,000 pounds GVWR. They cannot operate a combination of vehicles (like tractor-trailers) that would require a Class A CDL. Specific endorsements may also be required for certain types of vehicles or loads.
In Alabama, the written Class B CDL test is primarily offered in English. However, some locations may offer the test in Spanish. It's important to note that federal regulations require all commercial drivers to read and speak English sufficiently to communicate with the general public, understand highway traffic signs and signals, and respond to official inquiries.
Yes, you can request test accommodations for the Class B CDL written exam in Alabama if you have a disability. You'll need to provide documentation of your disability and specify the type of accommodation needed. The Alabama Law Enforcement Agency will review your request and determine if the accommodation can be provided without compromising the integrity of the test.
Yes, if you don't pass the Class B CDL written test in Alabama, you can retake it. However, you must wait at least one day before retaking the test. If you fail the test three times, you will need to start the application process over, including paying the necessary fees. It's recommended to study thoroughly to increase your chances of passing on your next attempt.