Air Brakes Endorsement Test | Utah 2024 #1

Train for FREE online with our Utah CDL air brake test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a UT Class A/Class B driver license in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that the requirements for CDL may vary from state to state.

Number of Question 25

Passing Score 20

Number of Tests 20

1 . Truck tractors with air brakes that were built on or after March 1, 1997 are equipped with:

An extra set of brakes.

Voice-activated brakes.

Cruise control.

Anti-Lock Braking Systems (ABS).

Truck tractors with air brakes that were manufactured on or after March 1, 1997 are required to be equipped with Anti-Lock Braking Systems (ABS). ABS is required in any other type of vehicle with air brakes that was manufactured on or after March 1, 1998.

2 . When using the controlled braking method in an emergency situation, you should:

Apply the brakes as hard as possible without locking the wheels.

Apply the brakes with about half of your usual force.

Apply the brakes so the wheels lock.

Apply the brakes with minimal pressure.

The controlled braking method for emergency stops involves applying the brakes as hard as you can without locking the wheels. Keep steering wheel movements small when braking in this way.

3 . Some air brake systems use alcohol:

To reduce the risk of ice forming in air brake valves.

To make the compressor run more efficiently.

To lubricate parts of the braking system.

To reduce the risk of rust forming on air brake valves.

Some air brake systems contain an alcohol evaporator. This device introduces alcohol into the braking system to inhibit the formation of ice.

4 . Air tank drains:

Allow rain water to enter the tanks.

Are used to drain water and oil from the air tanks.

Should never be opened.

Must remain open while driving.

Compressed air in an air brake system usually contains a certain amount of water and compressor oil. The water and oil can damage the brakes if left to accumulate in the system. Manually operated air tank drains must be opened daily to remove this build-up.

5 . What happens if the air pressure in a system's air tanks falls below 60 psi?

A warning light will come on.

The vehicle will not shift out of gear.

The front lights will flash.

The vehicle should stop.

In an air brake system, a low pressure warning signal should activate if the pressure in the air tanks falls to a level below 60 psi. This signal may be in the form of a warning light or a wig wag.

6 . When traveling down a steep downgrade:

The air brakes should be used.

Shift into a lower gear, then use brakes to supplement the braking effect of the engine.

The vehicle should be continually downshifted in the place of using the brakes.

The vehicle should be driven on the shoulder.

On a downgrade, the braking effect of the engine should be your primary method of controlling speed. Shift down to a lower gear before starting down the hill and save the brakes for additional slowing or stopping that may be required by road or traffic conditions.

Study tip:

Reduce your study time from hours to minutes with a DMV exam “Cheat Sheet”

99.2% of people who use the cheat sheet pass the FIRST TIME

Click Here
Full Cheat Sheet

99.2%

99.2% of people who use the cheat sheet pass the FIRST TIME

2024 Utah | Frequently Asked Questions

A CDL Class B license in Utah permits drivers to operate single vehicles with a gross vehicle weight rating (GVWR) of 26,001 pounds or more, or a towed vehicle not exceeding 10,000 pounds GVWR. This includes straight trucks, large buses, segmented buses, box trucks, and dump trucks with small trailers. The license requires passing a general knowledge test and a skills test.

A Class B CDL license in Utah allows the holder to operate single vehicles with a gross vehicle weight rating (GVWR) of 26,001 pounds or more, or a towed vehicle not exceeding 10,000 pounds GVWR. These vehicles include straight trucks, large buses, segmented buses, dump trucks with small trailers, and box trucks.

To acquire a Class B CDL license in Utah, applicants must be at least 18 years old (21 for interstate driving), possess a valid Utah driver's license, pass a vision test, and a written knowledge test. They must also complete a CDL application, provide medical certification, and successfully pass the Class B vehicle skills test.

In Utah, to qualify for a Class B Commercial Driver's License (CDL), you must be at least 18 years old. However, if you intend to drive across state lines or transport hazardous materials, federal regulations require you to be at least 21 years old.

While a Class B CDL license in Utah allows you to operate certain types of heavy vehicles, specific endorsements may be necessary based on the vehicle's features or cargo. For instance, a passenger endorsement is needed for vehicles carrying 16 or more passengers and a hazardous materials endorsement for transporting hazardous substances. Endorsements require additional written and skills tests.

The Class B CDL skills assessment in Utah consists of three sections: pre-trip vehicle inspection, basic vehicle control, and on-road driving. You'll be tested on your ability to inspect your vehicle before departure, control the vehicle under various conditions, and drive safely in regular traffic situations.

Yes, Class B CDL license holders in Utah are limited to operating vehicles with a Gross Vehicle Weight Rating (GVWR) of 26,001 or more pounds. They can also tow vehicles that weigh less than 10,000 pounds. They aren't allowed to drive a Class A vehicle without the proper endorsements.

In Utah, the written Class B CDL test is primarily administered in English, in accordance with federal regulations. However, assistance may be available for individuals with limited English proficiency. It's advisable to contact the Utah Driver License Division directly to discuss possible accommodations or assistance.

Yes, you can request accommodations for the Class B CDL written exam in Utah if you have a disability. It's recommended to contact the Utah Driver License Division ahead of your testing date to discuss your needs and arrange appropriate accommodations. These may include extra time, a separate room, or a reader, depending on your specific needs.

If you don't pass the Class B CDL written test in Utah, you can retake it. However, you must wait until the next day to retake the test. There is no limit on the number of times you can retake the test, but a retest fee applies each time after the third attempt.