Air Brakes #1
Air Brakes Endorsement Test | Tennessee 2024 #1 Page 4 of 4
Train for FREE online with our Tennessee CDL air brake test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a TN Class A/Class B driver license in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that the requirements for CDL may vary from state to state.
25
20
20
19 . To make a stop in a vehicle equipped with air brakes, the driver should:
To make a normal stop in a vehicle that is equipped with air brakes, you should simply press the brake pedal down.
20 . The brake pedal is part of which braking system?
The auxiliary brake system
The service brake system applies and releases the brakes when a driver presses the brake pedal while driving normally.
21 . During a walk-around inspection, ensure there are no cracks on the brake drums that are more than ____ of the width of the friction area.
One tenth
Before beginning a trip, it is important to check the brake drums during your walk-around inspection. It is unsafe to drive if any brake drum has a crack more than one half of the width of the friction area.
22 . Front brake limiting valves were intended to:
Remove uncertainty when applying the brakes.
Some older vehicles with air brakes have front brake limiting valves. These valves were intended to reduce the risk of front wheels skidding. However, research has shown that such devices are unnecessary, so they should be left in the "normal" position.
23 . Dollies equipped with ABS are required to have malfunction lamps located where?
On the top
A dolly equipped with an Anti-Lock Braking System (ABS) is required to have a yellow malfunction lamp located on its left side.
24 . Do not operate a vehicle if any brake drums have cracks that are larger than ____ of the width of the friction area.
Before beginning a trip, it is important to check the brake drums during your walk-around inspection. It is unsafe to drive if any brake drum has a crack more than one half of the width of the friction area.
25 . When leaving your vehicle unattended:
In general, you should always use the parking brake when parking your vehicle. However, you should not apply the parking brake if your brakes are very hot or if your brakes are wet and temperatures are below freezing.
Search the best driving school in your neighbourhood
2024 Tennessee | Frequently Asked Questions
A CDL Class A license in Tennessee allows the holder to operate any combination of vehicles with a Gross Combination Weight Rating (GCWR) of 26,001 pounds or more, provided the Gross Vehicle Weight Rating (GVWR) of the vehicle(s) being towed exceeds 10,000 pounds. It covers vehicles like tractor-trailers, truck and trailer combinations, and flatbeds.
A Class A CDL license in Tennessee allows the holder to operate vehicles such as tractor-trailers, truck and trailer combinations, flatbeds, tanker vehicles, and livestock carriers. It is typically used for long-haul or over-the-road (OTR) trucking. The license covers any vehicle with a GCWR of 26,001 pounds or more if the towed vehicle is over 10,000 pounds.
To obtain a Class A CDL license in Tennessee, you must be at least 21 years old (18-20 years for intrastate driving), possess a valid Tennessee driver's license, pass a vision test, and successfully complete both a knowledge test and a skills test. You'll also need to provide proof of citizenship or lawful permanent residency.
In Tennessee, you must be at least 21 years old to qualify for a Class A Commercial Driver's License (CDL) for interstate driving. However, you can obtain a Class A CDL for intrastate driving (within Tennessee) if you are at least 18 years old.
Specific endorsements are not required for a Class A CDL license, but they can expand your job opportunities. Endorsements allow you to operate specific types of vehicles, such as tank vehicles (N), passenger vehicles (P), school buses (S), or vehicles carrying hazardous materials (H). Each endorsement requires passing additional knowledge and/or skills tests.
The Class A CDL skills test in Tennessee encompasses three parts: a pre-trip inspection to confirm that your vehicle is safe to drive, a basic vehicle control test to demonstrate your ability to maneuver and control the vehicle, and an on-road driving test where you'll be evaluated on your interaction with traffic and adherence to safety rules.
Yes, there can be limitations on Class A CDL license holders. These are typically represented as restrictions noted on the license. For example, if you take your skills test in a vehicle without air brakes, you'll have an "L" restriction and can't operate vehicles with air brakes. Other restrictions can relate to medical conditions or the specific type of vehicle used for testing.
In Tennessee, the Class A CDL written test is primarily administered in English. However, some locations may offer the test in Spanish. It's important to note that all CDL holders must be able to read and speak English well enough to communicate with the general public, understand highway traffic signs and signals, respond to official inquiries, and make entries on reports and records.
Yes, you can request accommodations for the Class A CDL written test if you have a disability. The Tennessee Department of Safety & Homeland Security is committed to ensuring accessibility for all test takers. You should contact them directly ahead of your scheduled test to discuss your specific needs and arrange appropriate accommodations.
If you don't pass the Class A CDL written test, you can retake it. However, you must wait at least one day before retesting. There's no limit on how many times you can retake the test, but each attempt requires a fee. It's advisable to study thoroughly before retesting to increase your chances of passing.
