Air Brakes #2
Air Brakes Endorsement Test | Texas 2025 #2
Train for FREE online with our Texas CDL air brake test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a TX Class A/Class B driver license in 2025, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that the requirements for CDL may vary from state to state.
25
20
22
1 . If the low pressure warning signal activates while you are driving, you should:
Put on your hazard lights and continue driving.
If the low pressure warning signal activates while you are driving, it is important that you safely exit the roadway as soon as possible and park your vehicle. If the air pressure gets too low, the brakes will no longer work well enough for you to stop safely.
2 . Which of the following is not a part of an air brake system?
An axle brake system
Air brakes consists of three separate braking systems: the service brake system, the parking brake system, and the emergency brake system.
3 . During an applied leakage test, the maximum leakage rate for a single vehicle with air brakes is:
4 psi in one minute.
It is important to know the maximum air loss rate that is safe for your specific vehicle. A single vehicle with air brakes should have a leakage rate no higher than 3 psi in a minute during an applied leakage test.
4 . A dual air brake system:
Has two separate air brake systems, but uses a single set of controls.
A dual air brake system has two separate air brake systems that use a single set of brake controls. One system typically operates the regular brakes on the rear axle or axles. The other system operates the regular brakes on the front axle.
5 . During a static leakage test, the maximum leakage rate for a single vehicle with air brakes is ____ in one minute.
4 psi
When performing a static leakage test on a single vehicle with air brakes, the leakage rate should be no more than 2 psi in a minute. If air leaks from the air brake system at a quicker rate, the vehicle should not be driven because something likely needs to be repaired.
6 . Pressing and releasing a brake pedal unnecessarily can:
Create a loud noise.
In an air brake system, pressing and releasing the brake pedal unnecessarily can release air from the braking system faster than the compressor can replace it.
2025 Texas | Frequently Asked Questions
A CDL Class B license in Texas allows the holder to operate single vehicles with a gross vehicle weight rating (GVWR) of 26,001 pounds or more, or any such vehicle towing another not exceeding 10,000 pounds. This includes buses, farm labor vehicles, and any combination of vehicles that are not Class A vehicles.
A Class B CDL license in Texas allows the holder to operate vehicles such as straight trucks, large buses, segmented buses, box trucks, dump trucks with small trailers, and tractor-trailers. However, it is important to note that any trailer being towed must not exceed a gross vehicle weight rating of 10,000 pounds.
To acquire a Class B CDL license in Texas, applicants must be at least 18 years old (21 for interstate driving), possess a valid Texas driver's license, pass a vision exam, and successfully complete a knowledge test. They must also pass a skills test, which includes a pre-trip vehicle inspection, a basic vehicle control test, and an on-road driving examination.
In Texas, you must be at least 18 years old to qualify for a Class B Commercial Driver's License (CDL) for intrastate driving (within Texas only). However, if you intend to drive across state lines (interstate driving), federal regulations require you to be at least 21 years old.
While not always necessary, specific endorsements can be added to a Class B CDL license in Texas to allow for the operation of special types of vehicles. These include passenger (P), school bus (S), and tanker (N) endorsements. Each endorsement requires additional knowledge tests, and some also require a skills test.
The Class B CDL skills assessment in Texas includes three parts: a pre-trip vehicle inspection to check your understanding of your vehicle and its operation, a basic controls test to assess your ability to control the vehicle, and a road test to evaluate your on-road driving skills in various traffic situations and environments.
Yes, there are limitations for Class B CDL license holders in Texas. They are permitted to operate single vehicles with a gross vehicle weight rating (GVWR) of 26,001 pounds or more, or tow a vehicle not exceeding 10,000 pounds GVWR. However, they cannot operate Class A vehicles unless they upgrade their license.
In Texas, the written Class B CDL test is primarily offered in English. However, Spanish versions are available. Please note that all CDL applicants must pass an English proficiency test, as federal regulations require all CDL holders to read and speak English sufficiently to communicate with the general public, understand highway traffic signs and signals, and respond to official inquiries.
Yes, the Texas Department of Public Safety (DPS) provides reasonable accommodations for individuals with disabilities during the Class B CDL written exam. You need to request these accommodations in advance. Contact your local DPS office for more information about the process and to discuss your specific needs.
Yes, if you don't pass the Class B CDL written test in Texas, you can retake it. However, you will need to wait at least one day before retesting. Keep in mind that additional fees may apply each time you retake the test. It's recommended to study thoroughly and use available practice tests to increase your chances of passing on the next attempt.