Combination Vehicles Practice Test | Alabama 2024 #1

Train for FREE online with our Alabama CDL combination vehicle test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a AL combination license in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that DMV requirements for issuing a combination license may vary from state to state.

Number of Question 20

Passing Score 16

Number of Tests 20

1 . When coupling, after you've connected the air lines to the trailer, you should:

Supply air to the trailer.

Activate the emergency brake.

Disconnect the glad hands.

Correctly following the steps to couple and uncouple trailers is vital to safely operating a combination vehicle. After connecting the air lines to the trailer while coupling, you should supply air to the trailer.

2 . To prevent a rollover, a driver should:

Keep cargo low.

Place cargo high.

Keep cargo loose.

Turn quickly.

Rollovers can happen when a combination vehicle is turned too quickly. To help prevent the risk of rollover, it is important to keep the vehicle's center of gravity low by loading cargo as close to the ground as possible.

3 . During a trip, the ____ should be open.

Rear service line shut-off valve

Rear supply line shut-off valve

Inner shut-off valves

When starting a trip, be sure that all shut-off valves are in the open position, except for the last valves on the rear trailer. It is important that air reaches the brakes on all trailers and that it is not able to escape from the back of the vehicle.

4 . When braking with ABS, you should:

Push the brake pedal harder than usual.

Push the brake pedal as you normally would.

Push the brake pedal more lightly than usual.

When operating a vehicle with an Anti-Lock Braking System (ABS), you should apply your brakes in the same manner as you would if operating a vehicle without ABS.

5 . When uncoupling a trailer, landing gear should be:

Raised completely.

Lowered halfway.

Just off the pavement.

Firmly on the ground.

Landing gear, or trailer supports, should always be completely raised before a vehicle is driven. When uncoupling, landing gear should be lowered to make firm contact with the ground. If a trailer is loaded when it is being uncoupled, you should lower the landing gear and turn the crank a few additional times to remove some weight from the trailer.

6 . Look into the back of the fifth wheel:

While testing your air brakes.

If your vehicle begins to skid.

When inspecting a coupling.

While inspecting a coupling, you should go under the trailer and look into the back of the fifth wheel. Ensure that the fifth wheel jaws are secured around the shank of the kingpin.

7 . If your trailer goes off course while you are backing, you should:

Continue the backing process without changing anything.

Pull the truck forward, readjust, and start backing again.

Get out of the truck and move the trailer into the right position.

Turn the steering wheel all the way to the left until the trailer straightens out.

If your trailer goes off course while you are backing, you should pull your truck forward and reposition your vehicle as needed before continuing to back up.

Study tip:

Reduce your study time from hours to minutes with a DMV exam “Cheat Sheet”

99.2% of people who use the cheat sheet pass the FIRST TIME

Click Here
Full Cheat Sheet

99.2%

99.2% of people who use the cheat sheet pass the FIRST TIME

2024 Alabama | Frequently Asked Questions

To acquire a CDL Tank endorsement in Alabama, you must first possess a Commercial Driver's License (CDL). Then, you need to pass the Tank Vehicle Endorsement Knowledge test, which covers the proper handling and driving of tank vehicles. Studying the Alabama CDL Manual can assist in preparing for this test. After passing, you will receive the Tank endorsement on your CDL.

To obtain a CDL Tank license, it's essential to first have a Commercial Driver's License (CDL). You must then pass the Tank Vehicle Endorsement Knowledge test, which focuses on the correct handling and driving of tank vehicles. It's important to thoroughly study the Alabama CDL Manual to prepare for this test. Upon passing, you'll receive your CDL Tank endorsement.

While Alabama does not mandate specific training or experience for a CDL Tank endorsement, you must pass the Tank Vehicle Endorsement Knowledge test. This test covers the handling and driving of tank vehicles. Studying the Alabama CDL Manual can help prepare for this test. Practical experience or training could be beneficial, but it is not a legal requirement.

Yes, to obtain a CDL Tank endorsement in Alabama, you need to pass the Tank Vehicle Endorsement Knowledge test. This test is in addition to the general CDL test. It covers specific knowledge related to the safe operation and handling of tank vehicles. Studying the Alabama CDL Manual can help you prepare for this exam.

The written test for the CDL Tank endorsement in Alabama covers several topics related to tank vehicles. These include inspecting tank vehicles, driving tank vehicles, and safe handling of liquid cargo. It also includes understanding the high center of gravity in tank vehicles, checking for leaks, and emergency procedures. The Alabama CDL Manual provides detailed information on these subjects.

During the CDL Tank endorsement assessment, skills such as safe driving techniques, proper loading and unloading procedures, handling high center of gravity, and understanding outage requirements are evaluated. Additionally, applicants must demonstrate knowledge of emergency response procedures and understanding of how to inspect tank vehicles for safety issues.

Yes, drivers with a CDL Tank endorsement must follow specific rules. They must not drive a tank vehicle unless it's empty if they lack the endorsement. This also applies to tanks that were previously used to transport hazardous materials unless purged of any residue. Additionally, drivers must comply with all federal and state regulations regarding the transport of hazardous materials.

No, a valid Commercial Driver's License (CDL) with a Tank endorsement is required to transport liquid or gaseous materials in a tank or tanks having an individual rated capacity of more than 119 gallons and an aggregate rated capacity of 1,000 gallons or more. Driving such vehicles without the proper endorsement is against federal and state law in Alabama.

You can add the CDL Tank endorsement to your current commercial driver's license. It is not necessary to apply for a new license. However, you will need to pass the Tank Vehicle test, and there may be additional fees involved. Always check with your local DMV for specific requirements and procedures.

Yes, handling hazardous materials requires a Hazardous Materials (HazMat) endorsement in addition to the CDL Tank endorsement. To obtain a HazMat endorsement, you must pass a written test and a Transportation Security Administration background check. It's essential to understand and comply with these regulations for safety and legal reasons.