Knowledge Test Class B #1
Class B Driving Test | Montana 2025 #1 Page 4 of 7
Train for FREE online with our Montana class B license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a MT CDL class B permit in 2025, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class B requirements may vary from state to state.
50
40
20
22 . To warn drivers behind you that you will be slowing down, you should:
To let drivers behind you know that you plan to slow down, lightly tap your brake pedal a few times to flash your brake lights. It is important to communicate your intentions to other drivers.
23 . If the low air pressure warning signal comes on, you should:
If the low air pressure warning signal comes on while you are driving a vehicle with air brakes, you should immediately bring the vehicle to a safe stop while you are still able to control the brakes. Inspect and repair the brakes as soon as possible.
24 . As part of the vehicle inspection test, a CDL applicant may be asked to:
When checking the engine compartment during the vehicle inspection test, you will need to check the engine oil level.
25 . You should always be able to stop within:
A minute of hitting the brakes.
You should always make sure that your vehicle will be able to stop within the area of the road that you are able to see. This means that you must slow down whenever conditions reduce visibility.
26 . Convex mirrors:
Are illegal to be used in most states.
Many large vehicles have curved, convex mirrors. Convex mirrors allow drivers to see a wider area than flat mirrors. However, they also make objects seem smaller and farther away than they really are.
27 . Poisonous fumes can enter the cab due to:
Under-inflated tires.
Defects in an exhaust system are very dangerous because they can cause poisonous fumes to enter the cab or sleeper berth.
28 . Which of the following is acceptable if found during a pre-trip inspection?
Cracks in the tires
When inspecting your tires, verify that there is tread depth of at least 4/32 of an inch in every major groove on the front tires and tread depth of at least 2/32 of an inch in grooves on the other tires. Be sure that your tires are not too worn, are not cracked, have proper air pressure, and are all equally sized.
2025 Montana | Frequently Asked Questions
To acquire a CDL Tank endorsement in Montana, you must first have a Commercial Driver's License (CDL). After that, study for the tank endorsement test using the Montana CDL manual. Schedule and pass the written test at your local Montana Motor Vehicle Division. Upon passing, you'll receive your tank endorsement. Fees may apply.
To obtain a CDL Tank license, you must first hold a valid Commercial Driver's License (CDL). Then, prepare for the tank endorsement test using the appropriate study materials, such as the state's CDL manual. After studying, schedule and pass the written test at your local Motor Vehicle Division. A fee is typically required for this process.
Specific training or experience isn't mandatory for a CDL Tank endorsement in Montana. However, studying the CDL manual thoroughly is strongly recommended to pass the written test. Practical experience or training could also be beneficial for understanding the unique handling characteristics and safety considerations of driving a tank vehicle.
Yes, to obtain a CDL Tank endorsement in Montana, you'll need to pass an additional written test. This test covers specific knowledge related to the safe operation and handling of commercial tank vehicles. Studying the relevant sections of your state's CDL manual is crucial to pass this test.
The written test for the CDL Tank endorsement in Montana covers subjects like inspecting tank vehicles, safe driving for tank vehicles, safe loading and unloading procedures, and understanding the special characteristics of tanks. You'll also learn about handling emergencies, including different types of hazardous materials spills.
The CDL Tank endorsement assessment primarily focuses on knowledge rather than specific driving maneuvers. It evaluates your understanding of inspecting tank vehicles, recognizing high center of gravity and its impact, maintaining safe control on curves, turns, and railroad crossings, and managing emergency situations like hazardous spills. It's about ensuring you can safely operate a tank vehicle under various conditions.
Yes, there are certain limitations for drivers with a CDL Tank endorsement. They are only allowed to operate commercial tank vehicles and are restricted from transporting hazardous materials unless they also have a Hazmat endorsement. Additionally, they must comply with all federal and state regulations regarding transport of liquids and gases.
No, drivers cannot transport liquid or gas materials without a valid CDL Tank endorsement. This endorsement is required by federal regulations to ensure that drivers are properly trained and understand the safety precautions necessary when transporting these types of materials. Violating this requirement can result in severe penalties.
The CDL Tank endorsement can be added to your existing Commercial Driver's License (CDL). You don't need to apply for a new license. However, you will need to pass the Tank Vehicle endorsement written test. Once you pass, the endorsement is added to your existing CDL. Be sure to check with your local DMV for any specific state requirements.
Yes, there are specific regulations and prerequisites for handling hazardous materials with a CDL Tank endorsement in Montana. These include passing the CDL written test for hazardous materials, undergoing a TSA background check, completing a hazardous materials endorsement application, and paying the required fees. Additionally, individuals must meet certain age and experience requirements and adhere to federal regulations for transporting hazardous materials.