Double #2
Double Triple Test | Montana 2025 #2
Train for FREE with our Montana CDL double triple practice test online. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a MT CDL double triple license in 2025, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that DMV requirements may vary from state to state.
20
16
20
1 . Move over laws:
Require all drivers to move into the left lane if a flatbed trailer is in the right lane.
If an emergency vehicle using its flashing lights is stopped on the side of a multilane road, move over laws require drivers to vacate the lane directly next to the vehicle, if possible. If a driver cannot move over safely, they must slow down and proceed with caution.
2 . The parking brake in a newer vehicle is applied by:
In newer vehicles with air brakes, the parking brake is controlled by a yellow, diamond-shaped knob. The driver should pull the knob outward to apply the parking brakes and push the knob inward to release them.
3 . When doing an inspection, ensure that the brake pads are:
Free of oil or grease.
When inspecting a vehicle's brakes, you should make sure the shoes and pads do not have oil, grease, or brake fluid on them.
4 . ____ is a thin layer of ice that forms on road surfaces.
Sharp ice
Black ice is a thin layer of ice that is clear enough for the road surface to be seen through it. A road covered in black ice may look like it is merely wet. You should be very careful when temperatures are below freezing and the road looks wet.
5 . Rollovers happen when:
ABS is working effectively.
Rollovers happen when a vehicle is driven too fast. To reduce the risk of rollover, make sure the weight of cargo is loaded low to the ground, and that you take turns and curves slowly.
6 . If a truck is equipped, a trailer brake hand valve can be used to:
Load cargo.
If a tractor-trailer is so equipped, the trailer brake hand valve can be used to stop the vehicle from rolling back when being started from a stop.
7 . Which of the following is not an example of a distracted person that motorists should be worried about?
A person sitting on a bench waiting for a bus
Be cautious when driving near people who are not paying attention to the road. Be wary of road workers, drivers who are engaged in conversation with passengers, and children near the road.
2025 Montana | Frequently Asked Questions
To acquire a CDL Tank endorsement in Montana, you must first have a Commercial Driver's License (CDL). After that, study for the tank endorsement test using the Montana CDL manual. Schedule and pass the written test at your local Montana Motor Vehicle Division. Upon passing, you'll receive your tank endorsement. Fees may apply.
To obtain a CDL Tank license, you must first hold a valid Commercial Driver's License (CDL). Then, prepare for the tank endorsement test using the appropriate study materials, such as the state's CDL manual. After studying, schedule and pass the written test at your local Motor Vehicle Division. A fee is typically required for this process.
Specific training or experience isn't mandatory for a CDL Tank endorsement in Montana. However, studying the CDL manual thoroughly is strongly recommended to pass the written test. Practical experience or training could also be beneficial for understanding the unique handling characteristics and safety considerations of driving a tank vehicle.
Yes, to obtain a CDL Tank endorsement in Montana, you'll need to pass an additional written test. This test covers specific knowledge related to the safe operation and handling of commercial tank vehicles. Studying the relevant sections of your state's CDL manual is crucial to pass this test.
The written test for the CDL Tank endorsement in Montana covers subjects like inspecting tank vehicles, safe driving for tank vehicles, safe loading and unloading procedures, and understanding the special characteristics of tanks. You'll also learn about handling emergencies, including different types of hazardous materials spills.
The CDL Tank endorsement assessment primarily focuses on knowledge rather than specific driving maneuvers. It evaluates your understanding of inspecting tank vehicles, recognizing high center of gravity and its impact, maintaining safe control on curves, turns, and railroad crossings, and managing emergency situations like hazardous spills. It's about ensuring you can safely operate a tank vehicle under various conditions.
Yes, there are certain limitations for drivers with a CDL Tank endorsement. They are only allowed to operate commercial tank vehicles and are restricted from transporting hazardous materials unless they also have a Hazmat endorsement. Additionally, they must comply with all federal and state regulations regarding transport of liquids and gases.
No, drivers cannot transport liquid or gas materials without a valid CDL Tank endorsement. This endorsement is required by federal regulations to ensure that drivers are properly trained and understand the safety precautions necessary when transporting these types of materials. Violating this requirement can result in severe penalties.
The CDL Tank endorsement can be added to your existing Commercial Driver's License (CDL). You don't need to apply for a new license. However, you will need to pass the Tank Vehicle endorsement written test. Once you pass, the endorsement is added to your existing CDL. Be sure to check with your local DMV for any specific state requirements.
Yes, there are specific regulations and prerequisites for handling hazardous materials with a CDL Tank endorsement in Montana. These include passing the CDL written test for hazardous materials, undergoing a TSA background check, completing a hazardous materials endorsement application, and paying the required fees. Additionally, individuals must meet certain age and experience requirements and adhere to federal regulations for transporting hazardous materials.