Air Brakes Endorsement Test | Arizona 2026 #2

Train for FREE online with our Arizona CDL air brake test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a AZ Class A/Class B driver license in 2026, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that the requirements for CDL may vary from state to state.

Number of Question 25

Passing Score 20

Number of Tests 20

1 . On flat surfaces, wheel chocks:

Can be used to prevent a parked vehicle from moving.

Make it easier for a parked vehicle to roll.

Should only be used on the front driver's side tire.

In situations where a driver cannot use a parking brake, wheel chocks can be used to hold a parked vehicle in place on a level surface.

2 . A slack adjuster should move no more than ____ from where it is attached to the push rod.

Two inches

Five inches

One inch

Before a trip, you should check each slack adjuster after parking, setting wheel chocks, and disengaging the parking brake. Pull the slack adjusters to make sure that they do not move more than about one inch from where the push rod is attached. If they move more than one inch, they may be out of adjustment and will need to be fixed.

3 . Which of the following is not part of a vehicle’s air brake system?

Air gauges

Low pressure warning device

Air filter

Components of an air brake system include an air compressor, an air compressor governor, air storage tanks, air tank drains, an alcohol evaporator, a safety valve, a brake pedal, foundation brakes, supply pressure gauges, an application pressure gauge, a low air pressure warning signal, a stop light switch, a front brake limiting valve (on some older vehicles), spring brakes, and parking brake controls.

4 . During an applied leakage test, what is the maximum leakage rate that is safe for a single vehicle with air brakes?

10 psi in one minute

5 psi in one minute

3 psi in one minute

It is important to know the maximum air loss rate that is safe for your specific vehicle. A single vehicle with air brakes should have a leakage rate no higher than 3 psi in a minute during an applied leakage test.

5 . What should happen before the air pressure in an air brake system tank falls below 55 psi?

The warning light should activate.

The vehicle will be unable to shift out of gear.

The front lights should flash.

The low air pressure warning signal must activate before the air supply pressure drops below 55 psi in the air tank. If the warning signal does not turn on when being tested during an inspection, the vehicle is not safe to drive.

6 . When traveling down a steep downgrade:

The air brakes should be used.

The vehicle should be placed in a low gear and the driver should use engine braking.

The driver should continually downshift instead of using the brakes.

On long and/or steep downgrades, you should primarily use engine braking to control the speed of your vehicle. Use your brakes only as a supplement to this effect.

Study tip:

Reduce your study time from hours to minutes with a DMV exam “Cheat Sheet”

99.2% of people who use the cheat sheet pass the FIRST TIME

Click Here
Full Cheat Sheet

99.2%

99.2% of people who use the cheat sheet pass the FIRST TIME

2026 Arizona | Frequently Asked Questions

In Arizona, to secure a CDL Doubles/Triples endorsement, you must first have a valid Commercial Driver's License (CDL). Then, you'll need to pass the Doubles/Triples endorsement knowledge test administered by the Arizona Department of Transportation. Studying the CDL manual and taking practice tests can help prepare for this exam.

To obtain a CDL Doubles/Triples license, you first need a valid Commercial Driver's License (CDL). You must then pass the Doubles/Triples endorsement knowledge test. Preparation can include studying the CDL manual, particularly sections on coupling and uncoupling and inspecting doubles and triples. Lastly, pay the required fees to the Arizona Department of Transportation.

While Arizona doesn't mandate specific training for a CDL Doubles/Triples endorsement, it's beneficial to have practical experience or training. Understanding how to handle these larger, more complex vehicles safely is crucial. You'll need to pass the Doubles/Triples Endorsement Test, so studying the CDL manual and possibly taking a preparation course could be helpful.

Yes, to obtain a CDL Doubles/Triples endorsement in Arizona, you must pass the Doubles/Triples endorsement knowledge test. This test assesses your understanding of specific rules and safety standards for operating these vehicles. Studying the CDL manual and taking practice tests can help you prepare for this exam.

The CDL Doubles/Triples endorsement test in Arizona is primarily a knowledge test, focusing on understanding safety rules and procedures rather than specific maneuvers. Key topics include coupling and uncoupling, inspecting doubles and triples, and managing the vehicles' size and weight. However, practical skills like maneuvering and controlling these large vehicles are crucial for safe operation on the road.

No, it is not permissible to operate double/triple trailers without a valid CDL Doubles/Triples endorsement in Arizona. Driving such vehicles without the proper endorsement is illegal and can result in serious penalties, including fines and suspension or revocation of your commercial driver's license.

The CDL Doubles/Triples endorsement can be added to your existing commercial driver's license. You do not need to initiate a new application for a separate license. However, you will need to pass the Doubles/Triples endorsement knowledge test and pay the appropriate fees to have this endorsement added to your CDL.

Yes, drivers with a CDL Doubles/Triples endorsement must adhere to specific limitations. For example, the maximum length for a trailer in a double/triple combination is 28.5 feet. Furthermore, drivers are restricted to hauling doubles/triples on designated highways and during specific hours of the day, as determined by state and federal regulations.

The maximum length for a trailer in a double/triple combination is 28.5 feet. In terms of weight, federal law allows a maximum gross vehicle weight of 80,000 pounds, but this can be influenced by the number and spacing of axles. However, states can set their own restrictions, so it's advisable to check with local authorities.

Yes, drivers with a CDL Doubles/Triples endorsement must follow specific safety regulations. These include maintaining a safe following distance, not exceeding speed limits, ensuring proper coupling and uncoupling of trailers, and conducting pre-trip inspections. Additionally, drivers must understand the high rollover risk associated with these trailers and the effects of "crack-the-whip" scenarios.