Combination #1
Combination Vehicles Practice Test | Wisconsin 2024 #1 Page 3 of 3
Train for FREE online with our Wisconsin CDL combination vehicle test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a WI combination license in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that DMV requirements for issuing a combination license may vary from state to state.
20
16
20
15 . After finishing a pre-trip inspection, you should:
Leave the emergency line valve open.
Before a trip, you should ensure that air reaches all air brakes on all trailers by opening up the rear emergency line and service line shut-off valves to listen for escaping air. Close both shut-off valves before beginning to drive.
16 . After connecting the air lines to the trailer while coupling, you should:
Connect the electrical cord.
Correctly following the steps to couple and uncouple trailers is vital to safely operating a combination vehicle. After connecting the air lines to the trailer while coupling, you should supply air to the trailer.
17 . When traveling more slowly than 40 mph, maintain at least ____ of following distance per every 10 feet of your vehicle.
Four seconds
At speeds below 40 mph, you should allow at least one second of following distance for every 10 feet of your vehicle. Follow the same formula when traveling at faster speeds, then add one additional second to your following distance. Remember that larger vehicles require more space to stop than smaller vehicles.
18 . After finishing a pre-trip inspection, you should:
Leave the rear shut-off valves open.
Before a trip, you should ensure that air reaches all air brakes on all trailers by opening up the rear emergency line and service line shut-off valves to listen for escaping air. Close both shut-off valves before beginning to drive.
19 . Rollovers happen when drivers:
Drive illegally.
A rollover happens as a result of a driver taking a turn at too high a speed. Be sure to take turns and curves safely and slowly.
20 . If you press the tractor air supply control and your trailer's spring brakes do not release, you should:
It is important that all of a vehicle's equipment is in proper working condition before beginning a trip. If a trailer's spring brakes do not release when you push in the tractor air supply control, you should make sure the air line connections are properly attached and sealed.
Search the best driving school in your neighbourhood
2024 Wisconsin | Frequently Asked Questions
In Wisconsin, obtaining a CDL Tank Endorsement requires passing a written test. To prepare, study the Tank Vehicles section of the Wisconsin Commercial Driver's Manual. After studying, schedule a test at your local DMV. If you pass, you'll need to pay a fee to add the endorsement to your CDL. Remember, you must already have a valid CDL to qualify.
To obtain a CDL Tank license, you must first possess a valid Commercial Driver's License (CDL). Then, study the Tank Vehicles section of your state's Commercial Driver's Manual. You'll need to pass the written tank vehicle endorsement test at your local DMV. Lastly, pay the required fee to add the endorsement to your CDL.
While specific training or experience isn't legally required for a CDL Tank endorsement, it's highly recommended. Knowledge about handling tank vehicles, understanding the surge effect, and knowing safety procedures is crucial. Studying the Tank Vehicles section of the Commercial Driver's Manual thoroughly helps. However, practical experience or training can significantly improve your understanding and driving skills.
Yes, to obtain a CDL Tank endorsement, you need to pass an additional written test. This test covers specific knowledge related to the safe operation of commercial tank vehicles. It includes topics like vehicle inspection, driving techniques, and dealing with emergencies. The content for this test can be found in the Tank Vehicles section of the Commercial Driver's Manual.
The written test for the CDL Tank endorsement includes topics such as: the inspection and operation of tank vehicles, understanding the "baffled" and "unbaffled" tanks, managing the surge effect, handling high center of gravity, safe driving techniques, and responding to emergencies or hazardous conditions related to tank vehicles. The goal is to ensure safe and knowledgeable operation of tank vehicles.
The CDL Tank endorsement assessment primarily evaluates your knowledge rather than specific driving maneuvers. It focuses on understanding the unique handling of tank vehicles, managing surge, comprehending the differences between baffled and unbaffled tanks, and dealing with hazardous materials. Practical skills are usually assessed during the general CDL road test, not in the tank endorsement test.
Drivers with a CDL Tank endorsement must comply with federal and state regulations. They cannot drive tank vehicles without a valid CDL and the Tank endorsement. Additionally, if the tank vehicle is carrying hazardous materials, they must also have a Hazmat endorsement. Exceeding weight limits, failing to secure loads properly, or not following safety regulations can lead to penalties or loss of the endorsement.
No, you cannot transport liquid or gas materials in a tank vehicle without a valid Commercial Driver's License (CDL) with a Tank endorsement. This is a federal requirement and applies in all states, including Wisconsin. Violating this rule can lead to serious penalties, including fines and suspension of your CDL.
The CDL Tank endorsement can be added to your current commercial driver's license. You don't need a fresh application for a new license. However, you will need to pass a knowledge test specific to tank vehicles, and in some cases, a skills test may also be required. Once you pass, the Tank endorsement will be added to your existing CDL.
Yes, handling hazardous materials with a CDL Tank endorsement requires additional certifications. You must possess a Hazardous Materials (Hazmat) endorsement along with your CDL Tank endorsement. To get this, you'll need to pass a written test on federal and state regulations for transporting hazardous materials and undergo a federal background check.
