Knowledge Test Class B #1
Class B Driving Test | Tennessee 2024 #1 Page 7 of 7
Train for FREE online with our Tennessee class B license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a TN CDL class B permit in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class B requirements may vary from state to state.
50
40
20
43 . A low air pressure warning signal should activate:
When tank pressure falls below 5 psi.
In an air brake system, a low air pressure warning signal must come on if air pressure in the tanks falls below 60 psi. This warning signal may come in the form of a light, a buzzer, or a wig wag.
44 . During a written exam:
Cell phones may be left on.
All electronic devices must be turned off while a written exam is being taken.
45 . Brake pads should:
Not have any oil or grease on them.
When inspecting your brakes, you should verify that the shoes and pads do not have any oil, grease, or brake fluid on them.
47 . If a vehicle is equipped with an Anti-Lock Braking System (ABS), when the vehicle is started:
After starting the engine of a vehicle equipped with an Anti-Lock Braking System (ABS), the indicator light should come on and then turn off. If the light stays on, something is wrong with the ABS.
48 . On flat surfaces, wheel chocks:
In situations where a driver cannot use a parking brake, wheel chocks can be used to hold a parked vehicle in place on a level surface.
49 . If you require a hazardous materials endorsement, you will be required to:
To obtain a hazardous materials endorsement, you must first undergo a background check, which includes submission of your fingerprints.
50 . A bridge formula:
Maximum axle weights are often set by a bridge formula, which sets a lower maximum weight for axles that are close together.
2024 Tennessee | Frequently Asked Questions
A CDL Class A license in Tennessee allows the holder to operate any combination of vehicles with a Gross Combination Weight Rating (GCWR) of 26,001 pounds or more, provided the Gross Vehicle Weight Rating (GVWR) of the vehicle(s) being towed exceeds 10,000 pounds. It covers vehicles like tractor-trailers, truck and trailer combinations, and flatbeds.
A Class A CDL license in Tennessee allows the holder to operate vehicles such as tractor-trailers, truck and trailer combinations, flatbeds, tanker vehicles, and livestock carriers. It is typically used for long-haul or over-the-road (OTR) trucking. The license covers any vehicle with a GCWR of 26,001 pounds or more if the towed vehicle is over 10,000 pounds.
To obtain a Class A CDL license in Tennessee, you must be at least 21 years old (18-20 years for intrastate driving), possess a valid Tennessee driver's license, pass a vision test, and successfully complete both a knowledge test and a skills test. You'll also need to provide proof of citizenship or lawful permanent residency.
In Tennessee, you must be at least 21 years old to qualify for a Class A Commercial Driver's License (CDL) for interstate driving. However, you can obtain a Class A CDL for intrastate driving (within Tennessee) if you are at least 18 years old.
Specific endorsements are not required for a Class A CDL license, but they can expand your job opportunities. Endorsements allow you to operate specific types of vehicles, such as tank vehicles (N), passenger vehicles (P), school buses (S), or vehicles carrying hazardous materials (H). Each endorsement requires passing additional knowledge and/or skills tests.
The Class A CDL skills test in Tennessee encompasses three parts: a pre-trip inspection to confirm that your vehicle is safe to drive, a basic vehicle control test to demonstrate your ability to maneuver and control the vehicle, and an on-road driving test where you'll be evaluated on your interaction with traffic and adherence to safety rules.
Yes, there can be limitations on Class A CDL license holders. These are typically represented as restrictions noted on the license. For example, if you take your skills test in a vehicle without air brakes, you'll have an "L" restriction and can't operate vehicles with air brakes. Other restrictions can relate to medical conditions or the specific type of vehicle used for testing.
In Tennessee, the Class A CDL written test is primarily administered in English. However, some locations may offer the test in Spanish. It's important to note that all CDL holders must be able to read and speak English well enough to communicate with the general public, understand highway traffic signs and signals, respond to official inquiries, and make entries on reports and records.
Yes, you can request accommodations for the Class A CDL written test if you have a disability. The Tennessee Department of Safety & Homeland Security is committed to ensuring accessibility for all test takers. You should contact them directly ahead of your scheduled test to discuss your specific needs and arrange appropriate accommodations.
If you don't pass the Class A CDL written test, you can retake it. However, you must wait at least one day before retesting. There's no limit on how many times you can retake the test, but each attempt requires a fee. It's advisable to study thoroughly before retesting to increase your chances of passing.