A driver should inspect wheels before a drive, specifically looking for damage on the wheels and rims. Wheels or rims that have had welding repairs are not safe for use.

Are acceptable on tires in the rear of the vehicle.

Are acceptable only when carrying a heavy load.

Are acceptable in combination vehicles.

Focusing on your mirrors for too long can be dangerous because you will have traveled a substantial distance without looking at the road ahead.

Look in the mirrors for extended periods of time.

Use only the driver’s side mirror.

Speeding traffic is the main cause of death and injury in work zones. Drive with special caution when traveling near road workers.

Careless behavior by construction workers

Equipment placed in the roadway

To maintain proper control of your vehicle, the steering wheel should be held firmly with both hands. Your hands should be positioned on opposite sides of the wheel.

Held by one hand to allow for other tasks, such as eating and drinking.

Held by one hand at a time, alternating between hands.

Cracked to allow for an improved grip.

Backing a large CMV is always dangerous because you will not be able to see everything behind you. If you must back up, use a helper, if possible.

Move quickly to get out of the way of other drivers.

Check each slack adjuster after parking on level ground, setting wheel chocks, and disengaging the parking brake. Pull the slack adjusters to make sure they do not move more than about one inch from where the push rod is attached. If they move more than one inch, they may be out of adjustment and will need to be fixed.

Chock the wheels and disengage the parking brake.

Park on a hill and test the brakes.

Put on gloves and push in the slack adjusters.

Remove the drum and look inside.

Chock the wheels and disengage the parking brake.

It is important for you to be aware of your surroundings at all times. To do this, regularly check your mirrors.

Not be used, as they are distracting.

Not be used unless there is traffic.

Be checked regularly, but only if it is cloudy.

Placards are diamond-shaped warning signs that are placed on the outside of vehicles carrying hazardous materials. Placards are used to identify the specific hazard classes of the cargo being carried.

Signs placed on a vehicle to identify cargo hazards

A type of tire used in snowy conditions

Class B Driving Test | Georgia 2024 #1 Page 7 of 7

Train for FREE online with our Georgia class B license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a GA CDL class B permit in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class B requirements may vary from state to state.

Number of Question 50

Passing Score 40

Number of Tests 20

Class B Driving Test | Georgia 2024 #1 Page 7 of 7

43 . Rims with welding repairs:

44 . When using mirrors while driving, you should:

45 . What is the number one cause of death and injury in work zones?

46 . The steering wheel should be:

47 . When backing, you should:

48 . To inspect slack adjusters on S-cam brakes, you need to:

49 . When driving, your mirrors should:

50 . What are placards?

See the exact questions that will be on the 2024 DMV exam.

Wait, before you go