Knowledge Test Class B #1
Class B Driving Test | Wisconsin 2024 #1 Page 7 of 7
Train for FREE online with our Wisconsin class B license test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a WI CDL class B permit in 2024, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that CDL class B requirements may vary from state to state.
50
40
20
43 . Passive railroad crossings:
Should never be crossed by a CMV.
Railroad crossings that are not controlled by any type of traffic control device are known as passive crossings. The decision to proceed across tracks at a passive crossing is entirely up to the driver.
44 . In general, the legal maximum height for a vehicle and load is:
22 feet
Wisconsin law generally limits the height of a vehicle, including its load, to no more than 13 feet, 6 inches.
45 . Too little weight on a steering axle can result in:
Improved gas mileage.
The weight of cargo in a vehicle needs to be balanced appropriately so that it does not interfere with the vehicle's safe handling. For example, if cargo is placed too far to the rear of a vehicle, the front axle will be under-weighted and the front wheels may not have enough traction for the driver to steer safely.
46 . When conducting a vehicle inspection, you must show each of the following, except:
That the oil pressure gauge comes on when brakes are used.
When checking the oil pressure gauge as part of a vehicle inspection test, you must ensure that it is working. The gauge should show increasing or normal oil pressure, or the oil pressure warning light should turn off. If equipped with one, the oil temperature gauge should begin a gradual rise to the normal operating range.
47 . When backing, it is best to:
Use a helper, if possible.
If you must drive in reverse, you should back up slowly and use the mirrors on both sides of your vehicle. Use a helper to monitor your blind spots whenever possible. You and the helper should agree on a signal for "stop."
48 . Braking mechanisms are located inside:
Drum brakes are attached to the wheels and located on the axles of a vehicle. The braking mechanisms that cause the vehicle to stop can be found inside of a drum brake.
49 . A low air pressure warning signal should activate:
When tank pressure falls below 5 psi.
In an air brake system, a low air pressure warning signal must come on if air pressure in the tanks falls below 60 psi. This warning signal may come in the form of a light, a buzzer, or a wig wag.
50 . Water that has collected on a roadway can cause:
The risk of hydroplaning begins when water has collected on the surface of a road.
2024 Wisconsin | Frequently Asked Questions
In Wisconsin, obtaining a CDL Tank Endorsement requires passing a written test. To prepare, study the Tank Vehicles section of the Wisconsin Commercial Driver's Manual. After studying, schedule a test at your local DMV. If you pass, you'll need to pay a fee to add the endorsement to your CDL. Remember, you must already have a valid CDL to qualify.
To obtain a CDL Tank license, you must first possess a valid Commercial Driver's License (CDL). Then, study the Tank Vehicles section of your state's Commercial Driver's Manual. You'll need to pass the written tank vehicle endorsement test at your local DMV. Lastly, pay the required fee to add the endorsement to your CDL.
While specific training or experience isn't legally required for a CDL Tank endorsement, it's highly recommended. Knowledge about handling tank vehicles, understanding the surge effect, and knowing safety procedures is crucial. Studying the Tank Vehicles section of the Commercial Driver's Manual thoroughly helps. However, practical experience or training can significantly improve your understanding and driving skills.
Yes, to obtain a CDL Tank endorsement, you need to pass an additional written test. This test covers specific knowledge related to the safe operation of commercial tank vehicles. It includes topics like vehicle inspection, driving techniques, and dealing with emergencies. The content for this test can be found in the Tank Vehicles section of the Commercial Driver's Manual.
The written test for the CDL Tank endorsement includes topics such as: the inspection and operation of tank vehicles, understanding the "baffled" and "unbaffled" tanks, managing the surge effect, handling high center of gravity, safe driving techniques, and responding to emergencies or hazardous conditions related to tank vehicles. The goal is to ensure safe and knowledgeable operation of tank vehicles.
The CDL Tank endorsement assessment primarily evaluates your knowledge rather than specific driving maneuvers. It focuses on understanding the unique handling of tank vehicles, managing surge, comprehending the differences between baffled and unbaffled tanks, and dealing with hazardous materials. Practical skills are usually assessed during the general CDL road test, not in the tank endorsement test.
Drivers with a CDL Tank endorsement must comply with federal and state regulations. They cannot drive tank vehicles without a valid CDL and the Tank endorsement. Additionally, if the tank vehicle is carrying hazardous materials, they must also have a Hazmat endorsement. Exceeding weight limits, failing to secure loads properly, or not following safety regulations can lead to penalties or loss of the endorsement.
No, you cannot transport liquid or gas materials in a tank vehicle without a valid Commercial Driver's License (CDL) with a Tank endorsement. This is a federal requirement and applies in all states, including Wisconsin. Violating this rule can lead to serious penalties, including fines and suspension of your CDL.
The CDL Tank endorsement can be added to your current commercial driver's license. You don't need a fresh application for a new license. However, you will need to pass a knowledge test specific to tank vehicles, and in some cases, a skills test may also be required. Once you pass, the Tank endorsement will be added to your existing CDL.
Yes, handling hazardous materials with a CDL Tank endorsement requires additional certifications. You must possess a Hazardous Materials (Hazmat) endorsement along with your CDL Tank endorsement. To get this, you'll need to pass a written test on federal and state regulations for transporting hazardous materials and undergo a federal background check.