Bus #1

Bus Driver Testing | Texas 2025 #1

Train for FREE online with our TX bus CDL test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a license in Texas in 2025, learn how to become a bus driver and then practice as much as..

Train for FREE online with our TX bus CDL test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a license in Texas in 2025, learn how to become a bus driver and then practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that DMV requirements for a bus driver may vary from state to state.

20
16
22

1 . A properly adjusted flat mirror should allow the driver to see:

The front bumper. Properly adjusted flat mirrors on a school bus should allow the driver to see 200 feet behind the bus, the base of each rear wheel, and the sides of the bus.

2 . Which of the following is not acceptable emergency equipment?

Four yellow squares During the vehicle inspection test, you will need to show emergency equipment, including spare electrical fuses; three red reflective triangles, six fuses, or three liquid burning flares; and a properly charged and rated fire extinguisher.

3 . After traveling under an overpass during the driving skills test, you may be asked to recall:

If there was a shoulder near the roadway. If you drive under an overpass during the on-road driving skills test, your examiner may ask you to recall the posted clearance or height of the overpass.

4 . When conducting a vehicle inspection, you must show each of the following, except:

That the oil pressure gauge comes on when brakes are used. When checking the oil pressure gauge as part of a vehicle inspection test, you must ensure that it is working. The gauge should show increasing or normal oil pressure, or the oil pressure warning light should turn off. If equipped with one, the oil temperature gauge should begin a gradual rise to the normal operating range.

5 . When should a bus start moving after students have boarded?

As soon as the students cross the standee line Once students have boarded a school bus, the driver should wait to move the bus until all of the passengers are seated and looking forward.

6 . Which of the following is not a backing maneuver that you will be asked to perform during the basic control skills test?

Blind offset Backing maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right, offset back/left, driver side parallel parking, conventional parallel parking, and alley docking.

7 . During a vehicle inspection, ensure that lug nuts are all of the following, except:

Free of rust. During a vehicle inspection test, you must ensure that all lug nuts are present, free of cracks and distortions, and showing no signs of looseness, such as rust trails or shiny threads. Verify that all bolt holes are free of cracks and distortions.

Reduce your study time from hours to minutes with a DMV exam “Cheat Sheet”

99.2% of people who use the cheat sheet pass the FIRST TIME

99.2%

99.2% of people who use the cheat sheet pass the FIRST TIME

2025 Texas | Frequently Asked Questions

A CDL Class A license in Texas permits drivers to operate any combination of vehicles with a Gross Combination Weight Rating (GCWR) of 26,001 pounds or more, provided the Gross Vehicle Weight Rating (GVWR) of the vehicle(s) being towed is over 10,000 pounds. It covers vehicles like tractor-trailers, truck and trailer combinations, and tank vehicles.
A Class A CDL license in Texas allows the holder to operate vehicles such as tractor-trailers, truck and trailer combinations, tank vehicles, livestock carriers, and flatbeds. These are typically vehicles with a Gross Combination Weight Rating (GCWR) of 26,001 pounds or more where the towed vehicle exceeds 10,000 pounds.
To obtain a Class A CDL license in Texas, you must be at least 18 years old (21 for interstate driving), possess a valid Texas driver's license, pass a vision exam, and successfully complete both a written knowledge test and a three-part skills test. Additionally, you must provide proof of citizenship or lawful presence and pass a medical examination.
In Texas, you must be at least 18 years old to qualify for a Class A CDL license for intrastate driving (within Texas only). However, to drive a commercial vehicle across state lines (interstate), federal regulations require drivers to be at least 21 years old.
Specific endorsements are not required for a Class A CDL license, but they can provide additional driving privileges. Endorsements include T for double/triple trailers, P for passenger vehicles, N for tank vehicles, H for hazardous materials, and S for school buses. Each endorsement requires passing additional written and/or skills tests.
The Class A CDL skills test in Texas includes three parts: a pre-trip vehicle inspection, a basic vehicle control test, and an on-road driving test. These are designed to assess your ability to safely operate and maintain a Class A commercial vehicle. The test must be taken in a vehicle representative of the one you'll be driving.
Yes, there can be limitations for Class A CDL license holders. These are called restrictions and are marked on the license. For example, if you cannot operate a manual transmission, you may have an automatic only restriction. If you don't pass the air brakes test, your license will show you're not permitted to drive vehicles with air brakes.
Yes, it is possible to take the written Class A CDL test in languages other than English in Texas. However, the Department of Public Safety recommends that applicants have a basic understanding of English due to the English Language Proficiency requirement, which mandates drivers understand traffic signs and signals in English.
Yes, you can request accommodations for the Class A CDL written test if you have a disability. Texas Department of Public Safety provides reasonable testing accommodations according to the Americans with Disabilities Act. However, you must provide adequate documentation of your disability and you may need to make the request in advance.
Yes, if you don't pass the Class A CDL written test in Texas, you can retake it. However, you must wait at least one day before retesting. If you fail the test three times, you are required to wait 30 days before retesting. After failing six times, you must wait 90 days. Each retake does require an additional fee.

Search the best driving school in your neighbourhood