Students who are about to unload a school bus should remain seated until the driver tells them that it is safe to exit. After exiting the bus, they should walk to a position that is at least 10 feet away from the bus so the driver can clearly see them.

Remain seated until they are told to exit.

Stand up and head toward the door while the bus is slowing down.

Exit the bus and stand directly next to the bus while it is being driven away from the stop.

When checking the engine compartment during the vehicle inspection test, you must check the power steering, water pump, alternator, and air compressor belts. In addition to cracks and frays, you should check the belts for snugness, allowing up to three-quarters of an inch of play at the center of each belt. If any of these items are not belt-driven, you must identify them and ensure that their components are operating properly, are not damaged or leaking, and are mounted securely.

The applicant must identify which items are not belt-driven, if any.

The belts should be checked for snugness, each with up to three inches of play.

The water pump belt does not need to be identified.

The air compressor belt should be removed.

The applicant must identify which items are not belt-driven, if any.

Properly adjusted flat mirrors on a school bus should allow the driver to see 200 feet behind the bus, the base of each rear wheel, and the sides of the bus.

The rear tires touching the ground.

The front tires touching the ground.

Only the roadway and no parts of the bus.

When properly adjusted, the outside side flat mirrors on a school bus should allow the driver to see along the sides of the bus; the rear tires touching the ground; and 200 feet behind the bus.

The front tires touching the ground

When checking your vehicle's pedals during a pre-trip inspection, you should ensure that there is nothing under or around the pedals that will obstruct their use. Make sure the pedals are in proper working condition and that the surfaces of the pedals are grooved, if applicable.

Nothing is obstrucing the pedals.

The pedal surface has been smoothed out.

Nothing is obstrucing the pedals.

There is something underneath the brake pedal.

A pre-trip inspection should be completed in the same way before every drive. Consistency will help you learn all of the proper steps and decrease the likelihood that you will forget to check something.

The same way each time to prevent you from forgetting anything.

Differently each time in order to place emphasis on different items.

The same way each time to prevent you from forgetting anything.

Bus Driver Testing | Arkansas 2024 #1 Page 3 of 3

Train for FREE online with our AR bus CDL test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a license in Arkansas in 2024, learn how to become a bus driver and then practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that DMV requirements for a bus driver may vary from state to state.

Number of Question 20

Passing Score 16

Number of Tests 20

Bus Driver Testing | Arkansas 2024 #1 Page 3 of 3

15 . To safely unload a bus, students should:

16 . When inspecting engine compartment belts during the vehicle inspection test:

17 . A properly adjusted flat mirror should allow the driver to see:

18 . What should properly adjusted outside side flat mirrors on a school bus allow the driver to see?

19 . When performing a pre-trip inspection, you should make sure that:

20 . Pre-trip inspections should be done:

See the exact questions that will be on the 2024 DMV exam.

Wait, before you go