Idaho Driver's Examination

Bus #2

FREE Online Bus Driver Testing | Idaho 2024

Train for FREE online with our ID bus CDL test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a license in Idaho in 2021, learn how to become a bus driver and then practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that DMV requirements for a bus driver may vary from state to state.

Number of Question 20

Passing Score 16

Number of Tests 20

1 . When backing a truck, you should:

Only use the side mirrors on the driver’s side.

Use both side mirrors.

Never use a helper.

Backing a commercial motor vehicle is always dangerous because you cannot see everything behind you. When backing, make frequent checks of the mirrors on both sides of the vehicle. Use a helper whenever possible.

2 . During a pre-trip inspection, belts should be:

Loosened.

Checked for tightness.

Scrubbed clean.

Left alone and not inspected.

When inspecting your vehicle, you should check all belts for tightness and excessive wear. You should learn how much "give" is appropriate for each belt.

3 . If driving on a surface with poor traction, a driver should accelerate slowly:

Because it is always good to accelerate slowly.

To keep from losing control of the vehicle.

So that they do not accelerate faster than the vehicle ahead.

To avoid a loss of control, you should accelerate slowly when driving in poor-traction conditions, such as rain or snow.

4 . You should ____ if the low pressure warning signal activates while you are driving.

Stop where you are and park

Exit the roadway as soon as safely possible

Continue driving normally

If the low pressure warning signal activates while you are driving, it is important that you safely exit the roadway as soon as possible and park your vehicle. If the air pressure gets too low, the brakes will no longer work well enough for you to stop safely.

5 . When backing with a trailer, turning toward the driver’s side is encouraged because:

The driver will have the best possible view.

Power lines should be on the passenger's side.

Other drivers can offer assistance on the passenger's side.

When driving in reverse, it is always recommended that a driver backs their vehicle toward its left side. This will allow the driver the best possible view of the rear of their vehicle.

6 . If driving so slowly that you could impede the flow of traffic, you should:

Drive on the shoulder.

Drive while using your emergency flashers.

Drive without using any lights.

If you must drive so slowly that you will impede the flow of traffic, you should turn on your four-way flashers to alert drivers behind you (as long as local laws allow the use of flashers).

7 . Slow down and be extra careful:

When traveling in normal traffic.

When driving on dry pavement.

When approaching a work zone.

Slow down and be especially careful when driving in and around work zones, in places where the pavement drops off sharply at the edge of the road, when foreign objects are present on the road, and on freeway on- and off-ramps.

Study tip:

Reduce your study time from hours to minutes with a DMV exam “Cheat Sheet”

99.2% of people who use the cheat sheet pass the FIRST TIME

Click Here
Full Cheat Sheet

99.2%

99.2% of people who use the cheat sheet pass the FIRST TIME

2024 Idaho | Frequently Asked Questions

To acquire a CDL Tank endorsement in Idaho, you must have a valid Idaho CDL. You'll need to pass the Tank Vehicle written test administered by the Idaho Transportation Department. Study the CDL manual's section on tank vehicles. After passing the test, pay the required endorsement fee to add it to your CDL.

To obtain a CDL Tank license, it's essential to have a valid Commercial Driver's License (CDL). You must pass the Tank Vehicle written test, which covers the specific knowledge needed to operate tank vehicles safely. Studying the tank vehicle section in the CDL manual is crucial for passing this test. Lastly, pay the endorsement fee.

While specific training or experience isn't legally mandatory for a CDL Tank endorsement in Idaho, it's highly recommended. Understanding how to handle large, liquid-filled tanks is crucial for safety. Studying the tank vehicle section of the CDL manual and practical experience driving tank vehicles can significantly increase your chances of passing the Tank Vehicle written test.

Yes, obtaining a CDL Tank endorsement in Idaho requires passing an additional written test. This test focuses on the knowledge necessary to safely operate tank vehicles. It covers topics like high center of gravity, surge, bulkheads, baffles, and safe driving rules. The information for this test is found in the tank vehicles section of the Idaho CDL manual.

The written test for a CDL Tank endorsement covers a range of topics related to tank vehicles. These include inspecting tank vehicles, driving tank vehicles, and understanding the unique handling characteristics of tankers. It also covers safety rules, such as managing the vehicle's center of gravity and dealing with surge.

The CDL Tank endorsement written test in Idaho doesn't assess specific driving skills or maneuvers. It is a knowledge-based test focusing on understanding specific rules and safety measures for tank vehicles. Topics include the vehicle's high center of gravity, handling surge, understanding bulkheads and baffles, and adhering to safe driving rules. Practical skills are assessed separately in the general CDL driving test.

Yes, drivers with a CDL Tank endorsement face certain limitations. They can only operate commercial vehicles designed to transport liquids or gaseous materials within a tank that is permanently or temporarily attached to the vehicle. They are also required to comply with specific safety standards and procedures, such as handling hazardous materials and managing high center of gravity and surge.

No, you cannot legally transport liquid or gas materials in a commercial vehicle without a valid CDL Tank endorsement in Idaho. This endorsement is specifically designed to ensure that drivers have the necessary knowledge and skills to safely handle such materials. Driving without the appropriate endorsement can result in significant fines and penalties.

In Idaho, you can add the CDL Tank endorsement to your current license. You will need to pass the Tanker Knowledge Test and pay an additional fee. No fresh application is necessary. Remember to meet all the requirements and provide the necessary documents when applying for the endorsement.

Yes, handling hazardous materials with a CDL Tank endorsement requires adherence to specific regulations. Drivers must pass the Hazardous Materials (HazMat) endorsement knowledge test, and undergo a TSA background check. They must also follow safety procedures for loading, unloading, and transporting hazardous materials, and be aware of emergency response procedures.