Washington Driver's Examination

Air Brakes #2

FREE Air Brakes Endorsement Test Online | Washington 2024

Train for FREE online with our Washington CDL air brake test. The official exam test consists of several obligatory parts, with all of them checking your knowledge of different blocks of road rules. If you need to obtain a WA Class A/Class B driver license in 2021, practice as much as possible. Free sample tests published on our website will help you check and improve your knowledge and boost your grades. Please bear in mind that the requirements for CDL may vary from state to state.

Number of Question 25

Passing Score 20

Number of Tests 20

1 . Air pressure should build up in a single air system within:

15 minutes.

12 minutes.

Three minutes.

In single air systems, air pressure should build from approximately 50 to 90 psi within three minutes.

2 . Lights that indicate that anti-lock brakes are not working are:

Gray.

Blue.

Yellow.

Vehicles equipped with Anti-Lock Braking Systems (ABS) have yellow malfunction lights to indicate issues in the braking system.

3 . Why should you regularly drain the air tanks?

Because the air gets old and needs to be replaced

Because compressed air contains some water and the water collects in the tanks

To allow for a change in pressure

Compressed air usually contains a certain amount of moisture and compressor oil, which can build up in the air storage tanks and damage the brake system. The tanks should be drained to clean out these accumulations. On a tank with a manual drain valve, draining should be performed at the end of each day of driving.

4 . Brakes out of adjustment will:

Work properly.

Cause some of the brakes to overwork and malfunction.

Allow better acceleration.

Brakes out of adjustment will fade before those that are properly adjusted. Brake adjustment must be checked frequently to help prevent brake issues.

5 . A low air pressure warning signal should activate:

When tank pressure falls below 120 psi.

When tank pressure falls below 60 psi.

When tank pressure falls below 10 psi.

In an air brake system, a low air pressure warning signal must come on if air pressure in the tanks falls below 60 psi. This warning signal may come in the form of a light, a buzzer, or a wig wag.

6 . During an applied leakage test, the maximum leakage rate for a triple combination vehicle is ____ in a minute.

2 psi

4 psi

6 psi

It is important to know the maximum air loss rate that is safe for your specific vehicle. A triple combination should have a leakage rate no higher than 6 psi in a minute during an applied leakage test.

Study tip:

Reduce your study time from hours to minutes with a DMV exam “Cheat Sheet”

99.2% of people who use the cheat sheet pass the FIRST TIME

Click Here
Full Cheat Sheet

99.2%

99.2% of people who use the cheat sheet pass the FIRST TIME

2024 Washington | Frequently Asked Questions

To acquire a CDL Hazmat endorsement in Washington, you must have a valid CDL. Next, pass the Hazardous Materials Endorsement Knowledge Test at a Washington State driver licensing office. Then, undergo a federal background check and fingerprinting at an approved location. Finally, after receiving clearance, visit a driver licensing office to add the endorsement to your CDL.

To obtain a CDL Hazmat license, you must first have a valid Commercial Driver's License (CDL). You also need to pass the Hazardous Materials Endorsement Knowledge Test. A federal background check and fingerprinting are also required. Additionally, you must be at least 21 years old and a U.S. citizen or have legal status in the U.S.

When applying for a CDL Hazmat endorsement, you'll need your current Commercial Driver's License (CDL), proof of U.S. citizenship or lawful permanent residency (like a birth certificate or green card), and a completed Medical Examination Report Form. Also, you'll need proof of your Social Security number and a completed Hazardous Materials Endorsement application.

Yes, there is a dedicated written test for the CDL Hazmat endorsement. This is known as the Hazardous Materials Endorsement Knowledge Test. It covers topics like loading and unloading hazardous materials, bulk packaging marking, driving and parking rules, and emergency response procedures. You must pass this test to get the Hazmat endorsement.

The Hazardous Materials Endorsement Knowledge Test for the CDL Hazmat endorsement covers a range of subjects including identification of hazardous materials, proper loading and unloading procedures, safety procedures in transport, emergency response procedures, and understanding of the Hazardous Materials Regulations. It also tests knowledge of placarding and marking requirements.

Yes, there are extra charges associated with obtaining a CDL Hazmat endorsement. These include fees for the written test, fingerprinting, and a background check. The exact costs can vary by state and the specific services used for fingerprinting and background checks. It's best to check with your local DMV for the most accurate information.

Yes, obtaining a CDL Hazmat endorsement does require a background check and security clearance. The Transportation Security Administration (TSA) conducts these checks to ensure that the applicant does not pose a security threat. The process includes fingerprinting, a review of criminal history, and immigration status check for non-U.S. citizens.

Yes, specialized training is mandatory for the CDL Hazmat endorsement. Applicants must pass the Hazardous Materials Endorsement Knowledge Test. Additionally, they must undergo a TSA background check. While not a formal "certification," these steps are necessary to ensure the driver understands how to safely handle hazardous materials.

No, you cannot legally transport hazardous materials without a valid Commercial Driver's License (CDL) with a Hazardous Materials (Hazmat) endorsement. This endorsement ensures that drivers have the necessary training and knowledge to handle hazardous materials safely and in compliance with the law. Violating this can result in hefty fines and penalties.

You can add the CDL Hazmat endorsement to your current CDL license. It doesn't require a new application for a CDL license. However, you will need to fill out a separate application for the endorsement, pass the Hazmat knowledge test, and complete a TSA background check before the endorsement is added to your existing CDL.