1 . If the spring brakes are on, you should:

Not use the brake pedal.
Press the accelerator.
Move the steering wheel.

2 . During a static leakage test, what is the maximum leakage rate that is safe for a double combination vehicle?

3 psi in one minute.
6 psi in one minute.
8 psi in one minute.

3 . What tells you how much pressure is in your vehicle's air tanks?

The supply pressure gauge
The ABS malfunction lamp
The tractor protection valve

4 . Braking mechanisms are located inside:

The fifth wheel.
A brake drum.
The landing gear.

5 . What kind of force do emergency brakes use?

Air pressure
Mechanical
Heavy

6 . Why should you regularly drain the air tanks?

Because the air gets old and needs to be replaced
Because compressed air contains some water and the water collects in the tanks
To allow for a change in pressure

7 . Air pressure should build up in a single air system within:

15 minutes.
12 minutes.
Three minutes.

8 . If an air compressor is belt-driven, the belt should be routinely checked to ensure that it is:

Thin.
Properly tightened.
Cracked.

9 . Once the air tanks are at an air pressure level of 125 psi, the air compressor governor will:

Stop the compressor from pumping air.
Release air from the tanks.
Begin pumping air into the tanks.

10 . During an inspection, slack adjusters on S-cam brakes should not move more than:

One foot.
One centimeter.
One inch.

11 . The parking brake in a newer vehicle is applied by:

Moving a lever to the right.
Pushing a yellow, diamond-shaped knob.
Pulling a yellow, diamond-shaped knob.

12 . Brake linings should be:

Loose.
Free of oil.
Soft.

13 . In a dual air brake system, if one air system is very low on pressure:

None of the brakes will work at all.
Either the front or rear brakes will not be fully operable.
There is usually no noticeable effect.
Study tip:

Reduce your study time from hours to minutes with a DMV exam “Cheat Sheet”

99.2% of people who use the cheat sheet pass the FIRST TIME

14 . During an applied leakage test, the maximum leakage rate for a double combination vehicle is ____ in a minute.

2 psi
4 psi
6 psi

15 . To ensure normal stopping power, drivers of vehicles equipped with a front brake limiting valve should:

Set the control to normal.
Set the control to the off position.
Set the control to the neutral position.

16 . During an applied leakage test, what is the maximum leakage rate that is safe for a single vehicle with air brakes?

10 psi in one minute
5 psi in one minute
3 psi in one minute

17 . What is often found in compressed air?

Water
Cardboard
Brake fluid

18 . ABS brakes:

Help you avoid wheel lockup.
Lock up your vehicle's wheels.
Prevent your vehicle from accelerating when going uphill.

19 . A low air pressure warning signal should activate:

When tank pressure falls below 120 psi.
When tank pressure falls below 60 psi.
When tank pressure falls below 10 psi.

20 . The air compressor is connected to the:

Transmission.
Engine.
Radiator.

21 . When parking, you should not use the parking brake if:

The brakes are very hot.
The brakes are very cold.
There is snow on the ground.

22 . An application pressure gauge shows:

How much air pressure is being applied to the brakes.
How much air pressure is available.
How much air pressure is required to stop a vehicle.

23 . What do the two systems of a dual air brake system share?

Hoses
An air compressor
Air tanks

24 . The ____ between an air compressor and reservoir tank prevents air from escaping if the air compressor has a leak.

Slack adjuster
One-way check valve
Tractor protection valve

25 . While driving, ____ generally holds spring brakes in place.

Air pressure
Electricity
Gasoline