Tank #2 - Alaska Cdl

1 . If using a helper when backing a vehicle, the helper should be located:

In front of the passenger's side of the vehicle. In front of the driver's side of the vehicle. Near the back of the truck. Click Here Full Cheat Sheet

2 . To make it easier to leave a parked position, you should park:

In a way that allows you to back up when exiting. In a way that allows you to pull forward when exiting. Only on the side of roadways, not in parking lots. Take a FREE Practice Test Now

3 . If the brakes pull to one side or the other when used:

They are working properly. They need to be checked. They will be the most effective. Take a FREE Practice Test Now

4 . On a shipping paper describing both hazardous and non-hazardous materials, the hazardous materials may be identified by being:

Listed first. Written in pencil. Listed in red ink. Take a FREE Practice Test Now

5 . How can you check hydraulic brakes?

Pump the brake pedal three times then apply firm pressure to the pedal for five seconds. The brake pedal should not move. Pump the brake pedal three times then apply firm pressure to the pedal for five seconds. The brake pedal should move slowly toward the floor. Pump the brake pedal three times then apply firm pressure to the pedal for five seconds. The brake pedal should slowly rise. Click Here Full Cheat Sheet

6 . If you plan to slow down, you can warn drivers behind you by:

Slamming on the brakes. Tapping the brakes a few times and before braking. Turning on one set of turn signals. Take a FREE Practice Test Now

7 . When parked on the side of the road:

Use only the rear flashing lights. Use only one set of turn signals. Use your four-way flashers. Take a FREE Practice Test Now

8 . When starting an engine, warning lights and buzzers should:

Turn on and stay on. Flicker occasionally. Turn off right away. Take a FREE Practice Test Now

9 . When making a tight maneuver, you should:

Not use your mirrors, as they can be distracting. Use your mirrors, but not too frequently. Use your mirrors frequently. Click Here Full Cheat Sheet

10 . How long should it take for oil pressure to reach a normal level when starting a vehicle?

A few seconds About a minute About four minutes Take a FREE Practice Test Now

11 . Skids caused by acceleration can usually be resolved by:

Accelerating. Removing your foot from the accelerator. Coming to a complete stop. Take a FREE Practice Test Now

Study tip: Reduce your study time from hours to minutes with a DMV exam “Cheat Sheet” 99.2% of people who use the cheat sheet pass the FIRST TIME Click Here Full Cheat Sheet

12 . If traveling at 55 mph on dry pavement, your minimum braking distance will be close to:

25 feet. 50 feet. 200 feet. Take a FREE Practice Test Now

13 . Hydroplaning:

Only occurs at extremely high speeds. Can occur at speeds as low as 30 mph. Happens most frequently when tire pressure is too high. Click Here Full Cheat Sheet

14 . When driving a vehicle, rough acceleration is:

Encouraged at slow speeds. Encouraged at all speeds. Discouraged at all speeds. Take a FREE Practice Test Now

15 . If a worker is present in a work zone, you should:

Continue driving at the posted speed limit. Slow to a speed under the posted speed limit. Drive in the grass. Take a FREE Practice Test Now

16 . If you must back up, it is helpful to:

Drive as fast as possible to complete the maneuver quickly. First walk the line of travel to look for obstacles. Use only the passenger side mirror. Take a FREE Practice Test Now

17 . After two violations of any state law regarding hand-held mobile phone use:

You will need to cancel your mobile phone service. Your CDL will be disqualified. You will be required to drive 10 mph under the posted speed limit for a period of time. Click Here Full Cheat Sheet

18 . A material’s hazard class reflects:

The risks associated with the material. How quickly the material must reach its destination. How much the material weighs. Take a FREE Practice Test Now

19 . When backing a truck, you should:

Only use the side mirrors on the driver’s side of the vehicle. Use both side mirrors. Not use a helper. Take a FREE Practice Test Now

20 . Most heavy vehicles use the ____ method when changing gears.

Double clutching Double shifting Triple clutching Take a FREE Practice Test Now